A rapid, simple, accurate and highly sensitive spectrofluorimetric method was developed for the simultaneous analysis of nebivolol hydrochloride (NEB) and amlodipine besylate (AML). The method was based on measuring the synchronous fluorescence intensity of the drugs at Δλ = 40 nm in methanol. Various experimental parameters affecting the synchronous fluorescence of the studied drugs were carefully studied and optimized. The calibration plots were rectilinear over concentration ranges of 0.05-1.5 µg/mL and 0.5-10 µg/mL for NEB and AML with limits of detection (LOD) of 0.010 and 0.051 µg/mL and limits of quantitation (LOQ) of 0.031 and 0.156, respectively. The peak amplitudes ((2) D) of the second derivative synchronous fluorimetry (SDSF) were estimated at 282 nm for NEB and at 393 nm for AML. Good linearity was obtained over the concentration ranges. The proposed method was successfully applied to the determination of the studied compounds in laboratory-prepared mixtures, commercial single and laboratory-prepared tablets. The results were in good agreement with those obtained using the comparison method. The mean percent recoveries were found to be 100.12 ± 0.77 and 99.91 ± 0.77 for NEB and AML, respectively.

Coronavirus disease 2019 (COVID‐19) is a contagious viral infection caused by coronavirus 2 (SARS‐CoV‐2) that causes severe acute respiratory syndrome. It has ravaged several countries and burdened many healthcare systems. As the process of authorizing a novel treatment for human use is extensive and involves multiple phases to obtain safety information and identify potential concerns. Therefore, the fastest and easiest choice was to use United States Food and Drug Administration (US FDA)‐approved drugs such as favipiravir and hydroxychloroquine. For the simultaneous estimation of both medications, a simple synchronous spectrofluorimetric approach was established in which both drugs were measured at 372 and 323 nm, respectively in the presence of each other without interference at Δλ 60 nm. The effect of various experimental conditions on synchronous fluorescence intensities were thoroughly investigated and optimized. The maximum synchronous fluorescence intensities were obtained at pH 5.4 using acetate buffer (0.2 M, 0.5 ml) and ethanol as a diluent. Excellent linearity ranges were obtained using 1.0–18.0 ng/ml and 10.0–120.0 ng/ml for favipiravir and hydroxychloroquine, respectively. The approach exhibited high sensitivity with detection limits down to 0.25 ng/ml and 1.52 ng/ml and quantitation limits down to 0.77 ng/ml and 4.62 ng/ml, respectively. Spiking human plasma samples with the studied drugs yielded high % recoveries, allowing a significant bioanalytical application. Moreover, the method was validated according to International Conference on Harmonization guidelines and further applied to commercial pharmaceutical preparations with good results.

We hereby introduce a sensitive fast straightforward spectrofluorometric method for the estimation of remdesivir and favipiravir. The two drugs are prescribed in some regimens to treat COVID‐19 pandemic disease, which is caused by SARS‐CoV‐2. The method is based on the first derivative synchronous spectrofluorimetry approach for the measurement of remdesivir and favipiravir. This was accomplished at 251 nm and 335 nm respectively using the first derivative order at delta lambda of 140 nm. A linear response with a correlation coefficient 0.9994 was achieved between the concentration and the derivative amplitudes in the ranges of 20.0–100.0 ng ml−1 and 40.0–100.0 ng ml−1 for remdesivir and favipiravir, respectively. The methods were validated for different parameters as stated by the pharmacopeial rules and were applied successfully for estimation of the studied drugs in their synthetic mixtures and in spiked human plasma samples. No significant difference was observed between the proposed and comparison methods as revealed from the analysis of data.

No abstract

No abstract