No abstract

No abstract

No abstract

Plastics based on low-density polyethylene (LDPE) blends generally have limited miscibility, and it is difficult to obtain a homogeneous blend. Although they show excellent properties, their thermal degradation rate is a concern. This work aims to realize a homogeneous blend with higher chitosan concentration, thus expected to increase its degradation properties. An extrusion technique successfully synthesized LDPE and chitosan blends. The mixtures were prepared by adding maleic anhydride (MA) and tert-butyl peroxybenzoate (TBPB) as a compatibilizer and initiator, respectively. The addition of MA and TBPB resulted in homogeneous blends and using chitosan concentration of 40 %wt resulted in better tensile strength and elongation at break. The water uptake increased along with chitosan concentration in the blends. The thermal behavior analysis of the blends conducted by simultaneous TG/DTA revealed that the increase of chitosan concentration tends to improve the blend's thermal degradation slightly. Moreover, chitosan addition resulted in approximately a hundred times larger biodegradability compared to plastics based on LDPE alone.

The water absorption behavior of different types of organophilic montmorillonite (OMMT)-filled polyamide 6/polypropylene nanocomposites with and without compatibilizers (maleated PP or PP-g-MA and maleated styreneethylene/butylene-styrene or SEBS-g-MA) was evaluated. Four different types of OMMT, i.e., dodecylamine-modified MMT (D-MMT), 12 aminolauric acid-modified MMT (A-MMT), stearylamine-modified MMT (S-MMT), and commercial organo-MMT (C-MMT) were used as reinforcement. The water absorption response of the nanocomposites was studied and analyzed by tensile test and morphology assessment by scanning electron microscopy (SEM). The kinetics of water absorption of the nanocomposites conforms to Fick's law. The M m and D are dependent on the types of OMMT and compatibilizers. The equilibrium water content and diffusivity of PA6/PP blend were increased by the addition of OMMT but decreased in the presence of compatibilizers. On water absorption, both strength and stiffness of the nanocomposites were drastically decreased, but the ductility was remarkably increased. Both PP-g-MA and SEBS-g-MA played an effective role as compatibilizers for the nanocomposites. This was manifested by their higher retention ability in strength and stiffness (in the wet and re-dried states), reduced the equilibrium water content, and diffusivity of the nanocomposites.