We present results of the Relic Axion Dark-Matter Exploratory Setup (RADES), a detector which is part of the CERN Axion Solar Telescope (CAST), searching for axion dark matter in the 34.67 μeV mass range. A radio frequency cavity consisting of 5 sub-cavities coupled by inductive irises took physics data inside the CAST dipole magnet for the first time using this filter-like haloscope geometry. An exclusion limit with a 95% credibility level on the axion-photon coupling constant of gaγ ≳ 4 × 10−13 GeV−1 over a mass range of 34.6738 μeV < ma< 34.6771 μeV is set. This constitutes a significant improvement over the current strongest limit set by CAST at this mass and is at the same time one of the most sensitive direct searches for an axion dark matter candidate above the mass of 25 μeV. The results also demonstrate the feasibility of exploring a wider mass range around the value probed by CAST-RADES in this work using similar coherent resonant cavities.

The CAST-CAPP axion haloscope, operating at CERN inside the CAST dipole magnet, has searched for axions in the 19.74 μeV to 22.47 μeV mass range. The detection concept follows the Sikivie haloscope principle, where Dark Matter axions convert into photons within a resonator immersed in a magnetic field. The CAST-CAPP resonator is an array of four individual rectangular cavities inserted in a strong dipole magnet, phase-matched to maximize the detection sensitivity. Here we report on the data acquired for 4124 h from 2019 to 2021. Each cavity is equipped with a fast frequency tuning mechanism of 10 MHz/ min between 4.774 GHz and 5.434 GHz. In the present work, we exclude axion-photon couplings for virialized galactic axions down to gaγγ = 8 × 10−14 GeV−1 at the 90% confidence level. The here implemented phase-matching technique also allows for future large-scale upgrades.

A technology reference study for a solar polar mission is presented. The study uses novel analytical methods to quantify the mission design space including the required sail performance to achieve a given solar polar observation angle within a given timeframe and thus to derive mass allocations for the remaining spacecraft sub-systems, that is excluding the solar sail sub-system. A 1 Department of Mechanical & Aerospace Engineering, malcolm.macdonald.102@strath.ac.uk parametric, bottom-up, system mass budget analysis is then used to establish the required sail technology to deliver a range of science payloads, and to establish where such payloads can be delivered to within a given timeframe. It is found that a solar polar mission requires a solar sail of side-length 100 -125 m to deliver a 'sufficient value' minimum science payload, and that a 2. 5μm sail film substrate is typically required, however the design is much less sensitive to the boom specific mass.

In this work, we present an investigation of the wind in the solar corona that has been initiated by observations of the resonantly scattered ultraviolet emission of the coronal plasma obtained with UVCS-SOHO, designed to measure the wind outflow speed by applying Doppler dimming diagnostics. Metis on Solar Orbiter complements the UVCS spectroscopic observations that were performed during solar activity cycle 23 by simultaneously imaging the polarized visible light and the H I Lyman-α corona in order to obtain high spatial and temporal resolution maps of the outward velocity of the continuously expanding solar atmosphere. The Metis observations, taken on May 15, 2020, provide the first H I Lyman-α images of the extended corona and the first instantaneous map of the speed of the coronal plasma outflows during the minimum of solar activity and allow us to identify the layer where the slow wind flow is observed. The polarized visible light (580–640 nm) and the ultraviolet H I Lyα (121.6 nm) coronal emissions, obtained with the two Metis channels, were combined in order to measure the dimming of the UV emission relative to a static corona. This effect is caused by the outward motion of the coronal plasma along the direction of incidence of the chromospheric photons on the coronal neutral hydrogen. The plasma outflow velocity was then derived as a function of the measured Doppler dimming. The static corona UV emission was simulated on the basis of the plasma electron density inferred from the polarized visible light. This study leads to the identification, in the velocity maps of the solar corona, of the high-density layer about ±10° wide, centered on the extension of a quiet equatorial streamer present at the east limb – the coronal origin of the heliospheric current sheet – where the slowest wind flows at about 160 ± 18 km s−1 from 4 R⊙ to 6 R⊙. Beyond the boundaries of the high-density layer, the wind velocity rapidly increases, marking the transition between slow and fast wind in the corona.

The ESO Very Large Telescope (VLT) has the capability to coherently combine the light from four 8m telescopes and from smaller Auxiliary telescopes with baselines 4m and 200m (VLT Interferometer or VLTI). The resulting resolution approaches 0.5 milli-arcsec at visible wavelengths and 1 milli-arcsec in the near infra-red. We estimate that about 2000 nearby bright stars can be resolved with these baselines. The surface of about 400 stars, mainly K and M giants, can be mapped with a resolution of a dozen pixels or better across the stellar surface. This resolution permits detailed studies of the structure of stellar atmospheres, their hydrodynamics and magneto-hydrodynamics. VLTI can easily resolve starspots and very likely also convection cells on an active K-type giant at 10pc distance. A marginal detection of the largest starspots on a very active solar-type star at the same distance may be possible, but it appears very unlikely that the surface structure on an inactive solar-type star can be imaged.We present computer simulations of stellar surfaces to study in detail the response of the interferometer to an extended, complex source. First results which simulate the end-to-end process in a simplified manner indicate that useful maps can be produced provided that a sufficient number of baselines are combined in Earth-rotation synthesis mode. We also give arguments that high spectral resolution will prove essential to constrain reconstructed maps.