The use of lyophilized demineralized bovine bone granules in socket preservation to fill in the extraction socket seems essential in preserving the alveolar bone dimension as it showed excellent soft and hard tissue healing. This study concludes that the alveolar bone socket exhibited a dynamic process of resorption from the first day of tooth extraction. Evidence shows the possibility of using bovine bone granules routinely in socket volume preservation techniques following tooth extraction.

Background:The aim of this study was to evaluate the stability of immediate implant placement for alveolar bone augmentation and preservation with bovine bone graft following atraumatic tooth extraction.Materials and Methods:This was a prospective interventional study with convenient sampling (n = 10). Thirty patients aged between 18 and 40 years, who needed noncomplicated tooth extraction of mandibular premolar tooth, were sequentially divided equally into three groups. In Group I, simple extraction was done and the empty extraction socket left to heal conventionally. In Group II, extraction sockets were filled with lyophilized bovine granules only. In Group III, immediate implants were placed into extraction sockets, and the buccal gap was also filled with bovine granules. All groups were subjected to cone beam computed tomography scan for radiological evaluation. Assessment of biomechanical stability (radiofrequency analysis [RFA] was performed at 9 months postoperative for Group III to assess the degree of secondary stability of the implants using Osstell. Repeated measure analysis of variance (ANOVA) test was applied when comparing within each group at three different time intervals, whereas one-way ANOVA was applied followed by post hoc-tukey test when comparing between groups. P < 0.05 was considered statistically significant.Results:Radiological assessment reveals a significant difference of bone resorption in alveolar dimension within Group I; 1.49 mm (P = 0.002), and 0.82 mm (P = 0.005), respectively, between day 0 and 3 months. Comparison between Group I and III showed a highly significant difference of bone resorption in ridge width at 3 months 2.56 mm (P = 0.001) and at 9 months interval 3.2 mm (P < 0.001). High RFA values demonstrating an excellent biomechanical stability were observed in Group III at 9 months postoperatively.Conclusion:The insertion of immediate implants in extraction sockets with bovine bone augmentation of the buccal gap was able to preserve a greater amount of alveolar ridge volume.

Background- Accessory maxillary ostium (AMO) has a major role to play in the aetiology of maxillary sinusitis. Mucosal thickening is one of the key radiographic features of chronic maxillary sinusitis. The aim of this study was to establish the relation between maxillary sinus mucosal thickening (MT) and occurrence of AMO using cone beam computed tomography (CBCT). Methods- CBCT scans of 400 maxillary sinuses from the records of 200 patients who seeked various dental treatments at the University Dental Hospital, Ajman, United Arab Emirates were evaluated. The incidence, anatomical position and maximal length of accessory maxillary ostia (AMO) in the maxillary antrum were reviewed using CBCT by two examiners. The association between MTs and AMOs were also analysed. Results- AMOs were found in 142 maxillary antra (35.5%). The inter-observer reliability for using CBCT to detect AMO was (k=0.83). There was no significant difference in the frequency of AMOs when the age (P=0.19) and gender (P=0.54) distribution were considered. Sinuses with AMOs, showed significantly greater frequency of MTs (p=0.001). AMOs with maximal length of less than 1mm were most commonly observed (51.40 %). AMOs with larger greater maximal length were associated with higher degrees of MT. The location of the AMOs, were not affected by the degree of MT. Conclusion- The study demonstrates a clear association between degree of MT and occurrence of AMO in the maxillary sinus. There is a greater probability of finding an AMO in the maxillary sinus if the MT in the sinus is more than 3 mm.

Background In individuals with nasal septal deviation (NSD), compensatory hypertrophy of the nasal turbinates occurs as a protective mechanism of the nasal passage from dry and cold air. NSD associated nasal turbinate hypertrophy is usually recurrent, requiring repetitive imaging. Therefore, a multiplanar imaging modality with a low radiation dose is best suited for long-term follow-up of this condition. This study aimed to evaluate the association of width of inferior turbinates and presence of concha bullosa with the degree of NSD using Cone beam computed tomography (CT). Methods The CBCT scans of 100 patients with NSD were selected as per convenience sampling and were evaluated by two maxillofacial radiologists. The width of the non-hypertrophied inferior turbinate (NHT) on the convex side of the NSD, and hypertrophic inferior turbinates (HT) on the concave side of the NSD were measured at three locations. The septal deviation angle (SDA) and the presence of concha bullosa (CB) were determined. Results A significant difference was observed in the anterior, middle, posterior, and mean widths between HT and NHT (p < 0.001). There was a significant difference in the widths of the HT and NHT among different types of NSD. A strong positive correlation (r = 0.71, p < 0.001) was found between SDA and the mean width of the HT. Age (P = 0.71) and gender (P = 0.65) had no significant difference among different types of NSD. Regression analysis revealed that the presence of CB (p = 0.01) and middle width of the HT (p < 0.001) are significant predictors of SDA and type of NSD. Conclusion The results of the present study reveal that the middle width of the HT and the presence of CB influence the degree of NSD. The present study results recommend the use of CBCT as a substitutive low radiation dose imaging modality for evaluation of NSD, CB, and associated inferior turbinate hypertrophy.

Introduction Nasal septal deviation (NSD) and concha bullosa (CB) are associated with airway obstruction in mouth breathers. Mouth breathing is associated with alterations in maxillary growth and palatal architecture. The aim of our study was to determine the effect of the presence of CB and NSD on the dimensions of the hard palate using cone-beam computed tomography (CBCT). Materials and methods A retrospective study was conducted using CBCT scans of 200 study subjects. The study subjects were divided into four groups based on the presence of CB and NSD. Septal deviation angle (SDA), palatal interalveolar length (PIL), palatal depth (PD) and maxillopalatal arch angle (MPAA) were measured in the study groups. Results The presence of NSD and CB was associated with significant (p < 0.001) differences in the palatal dimensions of the study subjects. The PIL and MPA (p < 0.001) were significantly reduced (p < 0.001), whereas the PD was significantly increased (p < 0.001) in study subjects with NSD and CB. There was no significant change in the palatal dimensions between the unilateral and bilateral types of CB. Among the palatal dimensions, the PIL had the most significant association (R2 = 0.53) with SDA and CB. There was a significant correlation between the palatal dimensions and SDA when CB was present along with NSD. Conclusion Based on the results of this study, it can be concluded that the presence of NSD and CB have a significant effect on the palatal dimensions and, therefore, they may be associated with skeletal malocclusion.