This paper deals with the fabrication, modeling and experimental characterization of a monitorable and renewable graphene-based pollution filter. The main goal is to demonstrate a method to monitor the status of such a filter in real time during its operating phases: pollutant adsorption, saturation, and regeneration. The filter is realized by a disk of pressed graphene nanoplatelets. This is a low-cost type of graphene which has recently drawn great interest due to its potential use in large scale industrial production. Here the nanomaterial is obtained through the exfoliation method assisted by microwave irradiation, by exploiting the thermal expansion of commercial intercalated graphite, according to a low-cost and ecologically friendly procedure. The filter is used here to adsorb acetonitrile, a toxic water-soluble organic compound that is present in some industrial solvents and paints. The monitoring method is based on the interpretation of the time variation of the electrical impedance measured during filter operation. There are two main results of the paper: Firstly, the graphene filter is shown to be effective in adsorbing the above pollutant, with the additional feature of being fully renewable: all the pollutant can be removed from the filter without the need of costly physical or chemical processes. Secondly, monitoring of the time-evolution of the electrical impedance allows efficient detection of the different phases of the filter life cycle: clean, polluted, saturated and regenerated. This feature is of potential interest since it enables the predictive maintenance of such filters.

This paper studies the temperature dependence of the electrical resistivity of low-cost commercial graphene-based strips, made from a mixture of epoxy and graphene nanoplatelets. An equivalent homogenous resistivity model is derived from the joint use of experimental data and simulation results obtained by means of a full three-dimensional (3D) numerical electrothermal model. Three different types of macroscopic strips (with surface dimensions of cm2) are analyzed, differing in their percentage of graphene nanoplatelets. The experimental results show a linear trend of resistivity in a wide temperature range (−60°C to +60°C), and a negative temperature coefficient . The derived analytical model of temperature-dependent resistivity follows the simple law commonly adopted for conventional conducting materials, such us copper. The model is then validated by using the graphene strips as heating elements by exploiting the Joule effect. These results suggest that such materials can be used as thermistors in sensing or heating applications.

This paper provides a study of some relevant electro-thermal properties of commercial films made by pressed graphene nano-platelets (GNPs), in view of their use as heating elements in innovative de-icing systems for aerospace applications. The equivalent electrical resistivity and thermal emissivity were studied, by means of models and experimental characterization. Macroscopic strips with a length on the order of tens of centimeters were analyzed, either made by pure GNPs or by composite mixtures of GNPs and a small percentage of polymeric binders. Analytical models are derived and experimentally validated. The thermal response of these graphene films when acting as a heating element is studied and discussed.