The light microscopic examination of cells directly on bioceramic materials in the transmission mode is impossible because many of these materials are opaque. In order to enable direct viewing of living cells and to perform time-lapse studies, nearly transparent bioceramic materials were developed. A dense and fine-grained transparent hydroxyapatite (tHA) was processed by a gel-casting route followed by low-temperature sintering (1000 degrees C). By virtue of its transparency, direct visualization of cellular events on this material is possible in transmitted light. In this study, the interaction of different bone cell types with the tHA ceramic was envisaged. Investigation of rat calvaria osteoblasts (RCO) cultured on tHA by means of transmission light microscopy indicated good cytocompatibility of tHA. Microscopic analysis of osteogenic-induced human bone marrow stromal cells (hBMSC) on tHA and quantitative analysis of their lactate dehydrogenase (LDH) activity at different time points of culture revealed favorable proliferation as well. An increase of the alkaline phosphatase (ALP) activity indicated the differentiation of osteogenic-induced hBMSC towards the osteoblastic lineage. In addition, the differentiation of human monocytes to osteoclast-like cells could also be demonstrated on tHA and was confirmed by fluorescent microscopy imaging of multinucleated cells on the transparent material.

Transparent hydroxyapatite (HAP) was prepared by sintering gel-cast powder compacts at 1000°C for 2 h; the resultant HAP material was studied using X-ray diffractometry, transmission electron microscopy, scanning electron microscopy, and microhardness measurement. Nanoscale HAP crystallites were prepared using a precipitation method that involved calcium nitrate and ammonium dihydrogen orthophosphate solutions; the preparation was conducted at a temperature of 0°C. The precipitate was gel-cast and sintered at 1000°C in the form of a transparent ceramic that had a uniform grain size of 250 m. The maximum Vickers microhardness obtained for a sample sintered at 1000°C was 6.57 GPa. The sintering behavior of gel-cast samples prepared from high-temperature-precipitated HAP was compared with that of material prepared at 0°C.

No abstract

The bi-layer porous-dense HA buttons are useful in preventing cosmetic defects over burr-hole sites on the scalp after cranial neurosurgical procedures. It does not interfere with current radiological imaging methods in the postoperative phase.

This paper deals with a method to evaluate the sharpness of the concentric needle electrode (CNE) and the consistency of sharpness on repeated penetration. An aluminum foil of standard thickness and properties was used as the penetration medium. A load profile was obtained as a function of time, and has been correlated with the shape and quality of grinding of the tip of the CNE. This load profile can be used as a quality evaluation method. This method is utilized for the assessment of the impairment of the needle tip on repeated penetration and hence for comparison of different needle electrode models.