With a recent increase in interest in metal-gas batteries, the lithium-carbon dioxide cell has attracted considerable attention because of its extraordinary carbon dioxide-capture ability during the discharge process and its potential application as a power source for Mars exploration. However, owing to the stable lithium carbonate discharge product, the cell enables operation only at low current densities, which significantly limits the application of lithium-carbon dioxide batteries and effective carbon dioxide-capture cells. Here, we investigate a high-performance lithium-carbon dioxide cell using a quinary molten salt electrolyte and ruthenium nanoparticles on the carbon cathode. The nitrate-based molten salt electrolyte allows us to observe the enhanced carbon dioxide-capture rate and the reduced dischargecharge over-potential gap with that of conventional lithium-carbon dioxide cells. Furthermore, owing to the ruthernium catalyst, the cell sustains its performance over more than 300 cycles at a current density of 10.0 A g −1 and exhibits a peak power density of 33.4 mW cm −2 .

Recently, maintenance applications around power lines have been actively studied. These applications usually supply power through magnetic energy harvesting(MEH) to devices around the power line. A major challenge for practical MEH is to overcome magnetic saturation, which can cause degradation of power density under a wide current range in the power line. In this paper, we propose a design methodology to harvest maximized output power by considering the saturation effect. To consider magnetic saturation, the output power model and the saturable magnetizing inductance model based on magnetizing current were comprehensively analyzed. Additionally, the critical point of saturation for the maximum harvested power was analyzed by considering different primary side current conditions. With the proposed design methodology, the accuracy and efficiency of the output model were verified with experimental results compared to the conventional model. To consider the real environment, a 150 kW class of AC resistor load bank was implemented to control the primary current from 0 to 100 A with power frequency of 60 Hz. Experimental results show that the proposed method can harvest an average power of 14.32 W on 70 A power line, which is an increase of 39.8 % compared with the conventional design method.

No abstract

This paper analyzes how over-coupled coils affect odd harmonic current and electromagnetic interference (EMI) in a wireless power transfer (WPT) system, and proposes design considerations for series inductors to solve the EMI problem. When the air gap of the coils of the WPT system decreases below a certain level and the coils are over-coupled, the odd harmonic component of the input impedance of the system decreases and odd harmonic currents increase. The increase in the odd harmonic components current quickly aggravates the EMI issues. To solve the EMI problem of the over-coupled WPT system, additional series inductors were applied to the system, and considerations for designing the series inductors were analyzed. When designing additional series inductors, power transfer efficiency, maximum power transfer, input impedance and odd harmonic components current must be considered. Using simulations and experiments, it was confirmed that the WPT system designed with analyzed considerations maintained relatively high efficiency and reduced EMI issues.