The tested toothpastes exhibited similar effects in terms of brushing abrasion on both sound and artificially demineralized enamel. Based on mean values without statistical significance, the lowest brushing abrasion values in the demineralized brushed enamel samples were detected in the Chitodent group.

Dens invaginatus is a developmental anomaly that results in an enamel-lined cavity intruding into the crown or root before the mineralization phase. This report presents regenerative endodontic treatment of a necrotic immature tooth with Oehler's type III dens invaginatus of a nine-year-old female patient. A diagnosis of dens invaginatus (Oehler's type III) and a large periapical lesion was established with the aid of cone-beam computed tomography (CBCT). In the presented case contrary to the classic revascularization protocol, mechanical instrumentation was performed which apparently did not interfere with the regeneration process. After mechanical instrumentation of the invaginated canal by manual K-files, the invaginated canal space was disinfected by triple antibiotic paste followed by blood clot induction from the periapical tissues and the placement of mineral trioxide aggregate. At one-year follow-up, the tooth remained clinically asymptomatic. Radiographic examination revealed complete healing of the periapical lesion. At the 20-month follow-up, the radiographic examination also showed that the open apex was closed and the walls of the root canal were thickened.

No abstract

No abstract

Aim: Incomplete polymerization of a resin material used for dental restoration affects the properties of the restoration. We evaluated the structural and mechanical properties of three different colored compomers cured with three different LED units to observe the characteristic changes occurring in different matches. Methods: Polytetrafluoroethylene molds (5 mm in diameter and 2 mm in thickness) were used to prepare disk-shaped sample specimens. Nine sample groups (each of five specimens) were prepared, three each of different compomer resin colors (gold, berry, and silver). Samples were cured using three different LED units (Optima, VALO, and Demi Ultra), according to the manufacturers' instructions. Microstructural properties of samples were characterized by determining the degree of curing using Fourier-transform infrared spectroscopy and by analyzing sample morphology under a scanning electron microscope. The Vickers hardness, compressive strength, and elastic modulus of the samples were measured to investigate their mechanical properties. Results: The degrees of curing decreased in the order of silver > berry > gold for all curing units. Conversely, gold compomers exhibited poorer mechanical values than the berry and silver counterparts. The Optima 10 unit yielded slightly higher degrees of curing than the other devices, followed by Demi Ultra and VALO light-curing units, respectively. Conclusion: The resin color affected the structural and mechanical properties of the compomers, possibly as a result of the complex interactions and relationships between the irradiation light and resin material, such as light absorbance and reflectance; thus, depending on the color as well as the curing protocol.