Electrochemical gating is the process by which an electric field normal to the insulator electrolyte interface shifts the surface chemical equilibrium and further affects the charge in solution [Jiang and Stein, Langmuir 26, 8161 (2010)]. The surface chemical reactivity and double-layer charging at the interface of electrolyte-oxide-semiconductor (EOS) capacitors is investigated. We find a strong pH-dependent hysteresis upon dc potential cycling. Varying salinity at a constant pH does not change the hysteretic window, implying that field-induced surface pH regulation is the dominant cause of hysteresis. We propose and investigate this mechanism in foundry-made floating-gate ion-sensitive field-effect transistors, which can serve as both an ionic sensor and an actuator. Termed the chemoreceptive neuron metal-oxide-semiconductor (CνMOS) transistor, it features independently driven control gates (CGs) and sensing gates (SGs) that are capacitively coupled to an extended floating gate (FG). The SG is exposed to fluid, the CG is independently driven, and the FG is capable of storing charge Q(FG) of either polarity. Asymmetric capacitive coupling between the CG and SG to FG results in intrinsic amplification of the measured surface potential shifts and influences the FG charge injection mechanism. This modified SG surface condition was monitored through transient recordings of the output current, performed under alternate positive and negative CG pulses. Transient recordings revealed a hysteresis where the current was enhanced under negative pulsing and reduced after positive pulsing. This hysteresis effect is similar to that observed with EOS capacitors, suggesting a field-dependent surface charge regulation mechanism at play. At high CG biases, nonvolatile charge Q(FG) tunneling into the FG occurs, which creates a larger field and tunes the pH response and the point of zero charge. This mechanism gives rise to surface programmability. In this paper we describe the operational principles, tunneling mechanism, and role of electrolyte composition under field modulation. The experimental findings are then modeled by a Poisson-Boltzmann formulation with surface pH regulation. We find that surface ionization constants play a dominant role in determining the pH tuning effect. In the following paper [K. Jayant et al., Phys. Rev. E 88, 012802 (2013)] we extend the dual-gate operation to molecular sensing and demonstrate the use of Q(FG) to achieve manipulation of surface-adsorbed DNA.

Abstract-Self-assembled monolayers (SAMs) of either ferrocenecarboxylic acid or 5-(4-Carboxyphenyl)-10,15,20-triphenylporphyrin-Co(II) (CoP) with a high-κ dielectric were integrated into the Flash memory gate stack. The molecular reductionoxidation (redox) states are used as charge storage nodes to reduce charging energy and memory window variations. Through the program/erase operations over tunneling barriers, the device structure also provides a unique capability to measure the redox energy without strong orbital hybridization of metal electrodes in direct contact. Asymmetric charge injection behavior was observed, which can be attributed to the Fermi-level pinning between the molecules and the high-κ dielectric. With increasing redox molecule density in the SAM, the memory window exhibits a saturation trend. Three programmable molecular orbital states, i.e., CoP 0 , CoP 1− , and CoP 2− , can be experimentally observed through a charge-based nonvolatile memory structure at room temperature. The electrostatics is determined by the alignment between the highest occupied or the lowest unoccupied molecular orbital (HOMO or LUMO, respectively) energy levels and the charge neutrality level of the surrounding dielectric. Engineering the HOMO-LUMO gap with different redox molecules can potentially realize a multibit memory cell with less variation. Index Terms-Coulomb blockade effect, high-κ dielectric, nonvolatile memory devices, reduction-oxidation (redox)-active molecules, self-assembled monolayer (SAM).

The chemoreceptive neuron metal-oxide-semiconductor transistor described in the preceding paper is further used to monitor the adsorption and interaction of DNA molecules and subsequently manipulate the adsorbed biomolecules with injected static charge. Adsorption of DNA molecules onto poly-L-lysine-coated sensing gates (SGs) modulates the floating gate (FG) potential ψ(O), which is reflected as a threshold voltage shift measured from the control gate (CG) V(th_CG). The asymmetric capacitive coupling between the CG and SG to the FG results in V(th_CG) amplification. The electric field in the SG oxide E(SG_ox) is fundamentally different when we drive the current readout with V(CG) and V(ref) (i.e., the potential applied to the CG and reference electrode, respectively). The V(CG)-driven readout induces a larger E(SG_ox), leading to a larger V(th_CG) shift when DNA is present. Simulation studies indicate that the counterion screening within the DNA membrane is responsible for this effect. The DNA manipulation mechanism is enabled by tunneling electrons (program) or holes (erase) onto FGs to produce repulsive or attractive forces. Programming leads to repulsion and eventual desorption of DNA, while erasing reestablishes adsorption. We further show that injected holes or electrons prior to DNA addition either aids or disrupts the immobilization process, which can be used for addressable sensor interfaces. To further substantiate DNA manipulation, we used impedance spectroscopy with a split ac-dc technique to reveal the net interface impedance before and after charge injection.

No abstract

No abstract