With the increasing capacity of wind turbines, the importance of the yaw system has gradually become more prominent. The supervisory control and data acquisition (SCADA) system of XEMC Windpower Co., Ltd. is used in this paper to analyze the yaw data of the No. 5 wind turbine of Baozhong Mountain Wind Farm in Hunan Province. In order to evaluate the power generation and the damage equivalent load (DEL) of the yaw bearing during the yaw process, an economic model predictive control (EMPC) yaw strategy based on light detection and ranging (LIDAR) was proposed. EMPC takes the yaw error and wind speed as the disturbance of the cost function (CF) at the same time by establishing the yaw bearing DEL look-up table in advance. Discrete adaptive yaw speed control set is proposed to adapt to different wind conditionssets. Finally, the effectiveness of EMPC is verified using the model of XE112-2000 wind turbine in simulation software Bladed.

This paper analyzes the yaw data of the 2.5MW wind turbine of XEMC Windpower Company, and the real wind information collected by the wind farm, and proposes a two-level economic model predictive control (TL-EMPC) yaw strategy based on ideal wind measurement by light detection and ranging (LiDAR). This strategy comprehensively considers the power loss caused by yaw misalignment and the structural loads of the yaw bearing during the yaw process, making the yaw system more efficient and economical: In the high wind speed range, the yaw system has a higher sensitivity by setting the threshold of the yaw error angle, so as to fully capture wind energy; in the low wind speed range, fully consider the fatigue load of the critical parts of the wind turbine during the yaw process, thus Improve the economy of the wind turbine yaw system. The fatigue load and limit load of the yaw actuator at different yaw speeds are analyzed, and the best yaw speed is obtained. The finite control set of the yaw speed is established, which is used as the constraint set of the second-level minimum objective function. Finally, an external controller was used to simulate the 2.5MW wind turbine model in Bladed, and the effectiveness of the control strategy was verified.

No abstract