The present paper reports a numerical study on the effects of aerodynamic sweep applied to a low-aspect-ratio, high-through-flow, state-of-the-art, axial transonic compressor design. Numerical analyses based on the Reynolds-averaged Navier-Stokes equations were used to obtain the performance of a conventional unswept rotor, a forward swept rotor, and an aft-swept rotor, at both design and off-design operating conditions. The numerical analyses predicted that the forward-swept rotor has a higher peak efficiency and a substantially larger stall margin than the baseline unswept rotor, and that the aft-swept rotor has a similar peak efficiency as the unswept rotor with a significantly smaller stall margin. The rig test confirmed the numerical assessment of the effects of aerodynamic sweep on the low-aspect-ratio, high-through-flow, transonic compressor rotor. Detailed analyses of the measured and calculated flow fields indicate that two mechanisms are primarily responsible for the differences in aerodynamic performance among these rotors. The first mechanism is a change in the radial shape of the passage shock near the casing by the endwall effect, and the second is the radial migration of low-momentum fluid to the blade tip region. Aerodynamic sweep can be used to control the shock structure near the endwall and the migration of secondary flows and, consequently, flow structures near the tip area for improved performance.

No abstract

A design trend evident in newly evolving aircraft turbine engines is a reduction in the aspect ratio of blading employed in fans, compressors, and turbines. As aspect ratio is reduced, various three-dimensional flow effects become significant which at higher aspect ratios could safely be neglected. This paper presents a new model for predicting the shock loss through a transonic or supersonic compressor blade row operating at peak efficiency. It differs from the classical Miller-Lewis-Hartmann normal shock model by taking into account the spanwise obliquity of the shock surface due to leading-edge sweep, blade twist, and solidity variation. The model is evaluated in combination with three test cases. Each was a low-aspect-ratio transonic stage which had exceeded its efficiency goals. Use of the revised shock loss model contributed 2.11 points to the efficiency of the first test case, 1.08 points to the efficiency of the second, and 1.38 points to the efficiency of the third.

Blade tip losses represent a major performance penalty in low aspect ratio transonic compressors. This paper reports on the experimental evaluation of the impact of tip clearance with and without plasma actuator flow control on performance of an U.S. Air Force-designed low aspect ratio, high radius ratio single-stage transonic compressor rig. The detailed stage performance measurements without flow control at three clearance levels, classified as small, medium and large, are presented. At design-speed, increasing the clearance from small to medium resulted in a stage peak efficiency drop of almost 6 points with another 4 point drop in efficiency with the large clearance. Comparison of the speed lines at high-speed show significantly lower pressure rise with increasing tip clearance, the compressor losing 8 percent stall margin with medium clearance and an additional 1 percent with the large clearance. Comparison of the stage exit radial profiles of total pressure and adiabatic efficiency at both part-speed and design-speed and with throttling are presented. Tip clearance flow-control was investigated using Dielectric Barrier Discharge (DBD) type plasma actuators. The plasma actuators were placed on the casing wall upstream of the rotor leading edge and the compressor mapped from part-speed to high-speed at three clearances with both axial and skewed configurations at six different frequency levels. The plasma actuators did not impact steady state performance. A maximum stall margin improvement of 4 percent was recorded in this test series. The large clearance configuration benefited the most with the plasma actuators. Increased voltage provided more stall margin improvement. Plasma actuator power requirements were almost halved going from continuous operation to pulsed plasma. Most of the improvement with the plasma actuators is attributed to the reduction in unsteadiness of the tip clearance vortex near-stall resulting in additional reduction in flow prior to stall.