This work reports on surface modification of polyethylene terephthalate (PET) polymer by an atmospheric pressure plasma jet (APPJ) operated with argon. A distinguishable feature of this device is that it terminates with a conical horn-like nozzle. Three different nozzles diameters were employed with the purpose to obtain uniform surface modification over large area. Treatments in small 3D objects that fit inside the conical horn were also conducted. In this study, water contact angle (WCA) measurements and X-ray photoelectron spectroscopy (XPS) were performed to assess the samples wettability and the surface elemental composition, as well as, their radial distribution. Plasma-induced changes on the polymer surface morphology were evaluated by Atomic Force Microscopy (AFM). Electrical characterization of the plasma and investigation of the effect of the gas flow rate on the discharge power were carried out. After the plasma treatment PET surface became more hydrophilic over the entire area covered by the nozzle. This effect is caused by the incorporation of oxygen containing polar groups on the surface. It was also observed that depending on process parameters, the plasma treatment can extend even outside the area of the conical horn. The degree of surface modification depends on plasma dose while the treatment uniformity is determined mostly by the distance to the sample. Overall, a quite uniform surface modification was obtained over the entire area covered by the jet nozzle. Thus, the results suggest that by simply changing the jet geometry and choosing the right treatment parameters one can achieve a uniform treatment over an area whose size is determined by the horn diameter.

No abstract

Atmospheric pressure plasma has the potential of being applied in pre-harvest processes as a sustainable technology for seed and plant treatment. In this study, a medium-scale volume dielectric barrier discharge reactor with a power density of 53.5 mW/cm3 was developed and applied for continuous treatment of larger amount of seeds. Within the argon plasma, reactive oxygen and nitrogen species were observed by optical emission spectroscopy. Short-term plasma treatment in the range of seconds of wheat and barley seeds revealed improved germination performance accompanied by altered seed surface properties. Depending on the exposure time, plasma displayed a positive impact on maximum germination and germination speed in both species. In line with this, the t50 values were significantly decreased for plasma treated seeds compared to untreated seeds for wheat and barley. Cumulative germination was enhanced from 20% up to 53% after 27 h of germination for wheat seeds treated from 10 s to 60 s with plasma. Barley seeds respond to the short plasma treatment times with increased germination of 10%–23% after 24 h observation time. Moreover, the seed surface of both plant species became more hydrophilic after plasma treatment supported by a decrease in the water contact angle and an increase in hydrophilic functional groups being detected by x-ray photoelectron spectroscopy. Water uptake by seeds was moderately increased after 2 h of imbibition for both plant species. The positive effects of plasma treatment on germination performance were still detectable after storage of seeds for one and two months.

No abstract

Plasma agriculture is a growing field that combines interdisciplinary areas with the aim of researching alternative solutions for increasing food production. In this field, plasma sources are used for the treatment of different agricultural goods in pre- and post-harvest. With the big variety of possible treatment targets, studied reactors must be carefully investigated and characterized for specific goals. Therefore, in the present study, a cone-shaped corona reactor working with argon was adapted for the treatment of small seeds, and its basic properties were investigated. The treatment of rapeseed using different voltage duty cycles led to an increase in surface wettability, possibly contributing to the accelerated germination (27% for 90% duty cycle). The discharge produced by the conical reactor was able to provide an environment abundant with reactive oxygen species that makes the process suitable for seeds treatment. However, operating in direct treatment configuration, large numbers of seeds placed in the reactor start impairing the discharge homogeneity.