No abstract

No abstract

Within the framework of a sustainable development, manufacturing bituminous mixtures while reducing energy and using less new aggregates and new bitumen may be considered as an important topic, according to the quantities of asphalts mixtures produced for creating and maintaining road networks. This work aims to study the interest and the potential problems when coupling the warm mix asphalt technology (WMA) and the use of high ratio of reclaimed asphalt pavement (RAP) in the mixture. Initially, a study on managing RAP is performed, aiming to show that separating RAP aggregates in several fractions leads to a higher control of RAP in terms of homogeneity. Homogeneity of RAP is a key point for increasing recycling rates. The present study coupling WMA and RAP is based on the French design method for manufacturing asphalt concretes, which includes gyratory compaction tests, French wheel tracking tests, complex modulus tests and fatigue tests. However, the French design method does not take into account the physical and chemical aging of bituminous mixtures with time. As we consider that coupling WMA and RAP may lead to aging problems, it was decided to use an aging process before performing the standard tests. The results show that a WMA containing a high ratio of RAP has good performances according to the standard relative to this material, whatever the test. However, this material tends to be more sensitive to fatigue than hot and warm mixes without RA

Ageing of asphalt binders leads to evolution of pavements mechanical performances, due to changes in their rheological behaviour and in the binder composition. Ageing leads to a hardening of asphalt, mainly due to the oxidation of the asphalt binder itself. Oxidation rate is influenced by several parameters, namely outside temperature, ultraviolet (UV) radiation and intrinsic characteristics of the mixture constituents. In order to assess physical and chemical characteristics of the binders in aged pavements, mixture samples of several centimetres in thickness are usually cored from the field. Binders are extracted from these asphalt samples. This process of extraction is typical but it does not allow differentiating bulk and surface characteristics. Indeed, only the surface binder is exposed to UV rays and weathering. In order to assess the ageing of only the surface layer, to verify, for instance the influence of ageing on adhesion characteristics, it is necessary to extract and recover only the surface asphalt binder. A new test protocol, presented in this paper, has been developed to fulfil this purpose. This protocol consists in sampling only small particles at the surface layer, extracting the binder from the particles and performing Fourier transform infrared spectroscopy (FTIR) tests to assess the ageing of the binder. As the quantity of binder is very small, a specific FTIR test method is used. This method consists in keeping the binder diluted in the solvent and placing the solution in the ray of the spectrometer to perform the measurement. This new method has been compared to a more typical one, which consists in applying the binder on a transparent plate after having extracted the binder from the solvent. Once it has been checked that the two methods provide the same results for three kinds of binders, surface ageing tests have been performed. Two different ageing processes were considered: an ageing on site and an accelerated ageing protocol using a climate chamber named Weatherometer (SUNTERTXXL+). In this chamber, temperature, humidity and rain are controlled. The comparison between the ageing in the laboratory and the field allowed correlating both processes to establish an accelerator factor with respect to the increase in carboxyl group.

Concrete is a building material used for sensitive infrastructures like dams or nuclear power reactors; however its behaviour remains badly known under extreme dynamical loading like rock falls, explosions or ballistic impacts. It is due both to the difficulty of reproducing experimentally such a loading and to the intrinsic complexity of concrete behaviour. Predicting its response under dynamic loading needs the experimental characterization of its static behaviour in compression under very high confinement. This paper first presents a new large capacity triaxial press and the manufacturing and testing procedures developed to perform the tests. Plain concrete specimens (centimetric aggregate dimension) were submitted to different loading paths up to an ultimate state associated to failure.