The preparation of fully inkjet printed capacitors containing ceramic/polymer composites as the dielectric material is presented. Therefore, ceramic/polymer composite inks were developed, which allow a fast one-step fabrication of the composite thick films. Ba0.6Sr0.4TiO3 (BST) is used as the ceramic component and poly(methyl methacrylate) (PMMA) as the polymer. The use of such composites allows printing on flexible substrates. Furthermore, it results in improved values for the permittivity compared to pure polymers. Three composite inks with varying ratio of BST to PMMA were used for the fabrication of composite thick films consisting of 33, 50 and 66 vol% BST, respectively. All inks lead to homogeneous structures with precise transitions between the different layers in the capacitors. Besides the microstructures of the printed thick films, the dielectric properties were characterized by impedance spectroscopy over a frequency range of 100 Hz to 200 kHz. In addition, the influence of a larger ceramic particle size was investigated, to raise permittivity. The printed capacitors exhibited dielectric constants of 20 up to 55 at 1 kHz. Finally, the experimental results were compared to different theoretical models and their suitability for the prediction of εcomposite was assessed.

An innovative ceramic ink system for thin inkjet-printed dielectric layers is presented, with which it is possible to avoid undesired drying effects. This system contains surface-modified Ba0.6Sr0.4TiO3 (BST) particles, a cross-linking agent, and a thermal radical initiator. The polymerization starts immediately after the ink drop contacts the heated substrate and therefore leads to very homogeneous topographies. Since an organic/inorganic composite ink is used, no sintering is needed after printing and thus printing on flexible substrates is possible. A comparison of the printing and drying behavior between modified and nonmodified BST with the described ink system is performed. The successful surface modification is confirmed via X-ray photoelectron spectroscopy (XPS). Topographies of different printed structures are compared by white light interferometry, the occurring polymerization is confirmed by measurements with an oscillatory rheometer, layer thicknesses are determined by scanning electron microscopy (SEM) images, and the capacitance of a printed capacitor is measured via impedance spectroscopy. It is successfully shown that the developed ink system enables the production of thin ceramic layers (<1 μm) with very homogeneous topographies since undesired drying effects can be avoided. The printed dielectric layers on flexible substrates have a high ceramic content and a high permittivity of 40.

The present work describes an experimental investigation that applies stereo particle image velocimetry in a cross-plane of a turbulent channel flow that is additionally perturbed by spanwise oscillatory body forces, induced by a plasma actuator and designed to mimic the effect of spanwise wall oscillations. The experiment is aimed at retrieving the forcing-correlated scales and the turbulent flow stochastic fluctuations for the measured cross-plane. The first are macroscopic scales and require a larger investigation domain while the latter benefit of a higher resolution. Furthermore, the extended flow-field dynamic range posed a challenge on the experiment design, finally leading to an optimal tradeoff. The results of the unactuated flow compare well to the direct numerical simulations of Hoyas and Jimenez ́ (2008), while the actuated case demonstrates strong near-wall momentum addition and spanwise modulation of the streamwise flow component.