No abstract

A novel design for an all-fiber bandpass filter based on a multimode interference reimaging phenomenon is presented. The filter has achieved low insertion loss with adequate bandwidth and isolation for coarse wavelength-division multiplexing. The filter can easily be made with any central wavelength that is compatible with the single-mode fiber used for its construction. The measured filter performance matches the theoretical predictions well. The filter can have broad applications in fiber-optic telecommunications, spectroscopy, and sensing.

No abstract

In this article, we propose a two‐dimensional indoor localization system using fingerprinting of received optical signals emitted from light emitting diodes (LEDs).The transmitters and receiver are designed and constructed to use visible light as the signal for localization. At the transmitter side, the input voltage/current is modulated with continuous waves before being sent to the LEDs, where each transmitter is assigned with a different frequency. At the receiver side, the power spectral density of the received signal is calculated and the location is estimated as one of the fingerprint locations using a novel but yet simple algorithm. Both the simulation and experiment have been conducted to evaluate the accuracy of the system in a controlled environment. We demonstrate that the system has the potential to estimate locations in the level of centimeters. © 2012 Wiley Periodicals, Inc. Microwave Opt Technol Lett 54:1218–1227, 2012

We present a simple fiber-based single-arm spectral interferometer to measure directly the second-order dispersion parameter of short lengths of fiber (< 50 cm). The standard deviation of the measured dispersion on a 39.5-cm-long SMF28(TM) fiber is 1x10(-4) ps/nm, corresponding to 1% relative error, without employing any curve fitting. Our technique measures the second-order dispersion by examining the envelope of the interference pattern produced by three reflections: two from the facets of the test fiber and one from a mirror placed away from the fiber facet at a distance that introduces the same group delay as the test fiber at the measured wavelength. The operational constraints on system parameters, such as required bandwidth, wavelength resolution, and fiber length, are discussed in detail. Experimental verification of this technique is carried out via comparison of measurements of single mode fiber (SMF28(TM)) with published data and via comparison of measurements of a dispersion compensating fiber with those taken using conventional techniques. Moreover, we used this new technique to measure the dispersion coefficient of a 45-cm-long twin-hole fiber over a 70 nm bandwidth. It is the first time dispersion measurement on this specialty fiber is reported.