We report on a comparative study of transfer doping of hydrogenated single crystal diamond surface by insulators featured by high electron affinity, such as Nb2O5, WO3, V2O5, and MoO3. The low electron affinity Al2O3 was also investigated for comparison. Hole transport properties were evaluated in the passivated hydrogenated diamond films by Hall effect measurements, and were compared to un-passivated diamond films (air-induced doping). A drastic improvement was observed in passivated samples in terms of conductivity, stability with time, and resistance to high temperatures. The efficiency of the investigated insulators, as electron accepting materials in hydrogenated diamond surface, is consistent with their electronic structure. These surface acceptor materials generate a higher hole sheet concentration, up to 6.5x1013 cm2, and a lower sheet resistance, down to 2.6 kX/sq, in comparison to the atmosphere-induced values of about 1x1013 cm2 and 10 kX/sq, respectively. On the other hand, hole mobilities were reduced by using high electron affinity insulator dopants. Hole mobility as a function of hole concentration in a hydrogenated diamond layer was also investigated, showing a well-defined monotonically decreasing trend

In this paper, an overview of recently reported low-noise amplifiers (LNAs), designed, and fabricated in GaN technology is provided, highlighting their noise performance together with high-linearity and high-robustness capabilities. Several SELEX-ES GaN monolithic technologies are detailed, providing the results of the noise characterization and modeling on sample devices. An in-depth review of three LNAs based on the 0.25-µm GaN HEMT process, marginally described in previous publications, is then presented. In particular, two robust and broadband 2-18-GHz monolithic microwave integrated circuit (MMIC) LNAs are designed, fabricated, and tested, exhibiting robustness to over 40-dBm input power levels; an X-band MMIC LNA, suitable for synthetic aperture radar systems, is also designed and realized, for which measurement results show a noise figure ∼2.2 dB with an associated gain >25 dB and robustness up to 41-dBm input power level.

We have performed a propagation measurement campaign at the University of Rome Tor Vergata, Rome, Italy. We have sounded the channel by a probing signal at a carrier frequency of 4.78 GHz modulated by a train of pulses having a duration of 0.4 ns shaped by a pseudonoise (PN) sequence. The measurement band falls (3.6-6 GHz) in the frequency range allowed by the FCC ruling for ultrawide-band (UWB) operations. To characterize the channel behavior over the large and the small scale, the transmitter is moved in six different positions on the floor, while the receiver is moved in 625 different locations within each room. The receiver locations are arranged in a square grid of 25×25 points with 2 cm spacing, i.e., less than half of the minimum wavelength of the transmitted signal. A total of 625×16 impulse responses are recorded in nonline-of-sight (NLOS) conditions, 625 in line-of-sight (LOS) conditions within the rooms and 11 LOS measurements are made in the corridor at incremental spacing of 1 m. We describe the measurement technique as well as the procedure by which we process the experimental data to extract the amplitude, phase and delay associated to each component of the multipath profiles. We also derive path-loss and shadowing models for the UWB indoor channel in both LOS and NLOS conditions. Finally, we present an accurate analysis of the time dispersion of the UWB channel

No abstract