No abstract

No abstract

Crosslinking of polyolefin elastomer (POE, ENGAGE™ 8480) with Dicumyl Peroxide (DCP) can have effects on its crystallization dynamics, crystal structure, and properties. The POE crosslinked uniformly has significantly lower crystalline ability than the one with only amorphous phase crosslinked, which, in turn, has weaker crystalline ability than neat POE. The crystallinity and melting point depend on how the POE is crosslinked. The neat POE and POE crosslinked in amorphous phase only, are investigated with DSC and in‐situ tensile/synchrotron radiation (WAXD/SAXS). In situ tensile/synchrotron X‐ray during a uniaxial stretching process indicates that severe crystal fragmentation is observed at a strain around 45%, and with further increase in strain. The stress in the crosslinked POE is significantly larger than neat POE. For both samples, crystal orientation increases sharply within the strain range up to 88% where orientation‐induced new crystals aligned in stretching direction are observed. The long period increases more in stretching direction for the crosslinked POE, consistent with larger stress in this sample, and the stress difference is more pronounced at large strains (27.3 vs. 10.9 MPa at a strain 435%). Permanent set of the crosslinked POE is smaller, consistent with less oriented crystals observed after the test for permanent set.

The dynamic crosslinking method has been widely used to prepare rubber/plastic blends with thermoplastic properties, and the rubber phase is crosslinked in these blends. Both polyolefin elastomer (POE) and ethylene-propylene-diene monomer rubber (EPDM) can be crosslinked, which is different from usual dynamic crosslinking components. In this paper, dynamic crosslinked POE/EPDM blends were prepared. For POE/EPDM blends without dynamic crosslinking, EPDM can play a nucleation role, leading to POE crystallizing at a higher temperature. After dynamic crosslinking, the crosslinking points hinder the mobility of POE chains, resulting in smaller crystals, but having too many crosslinking points suppresses POE crystallization. Synchrotron radiation studies show that phase separation occurs and phase regions form in non-crosslinked blends. After crosslinking, crosslinking points connecting EPDM and part of POE chains, enabling more POE to enter the EPDM phase and thus weakening phase separation, indicates that dynamic crosslinking improves the compatibility of POE/EPDM, also evidenced by a lower β conversion temperature and higher α conversion temperature than neat POE from dynamic mechanical analysis. Moreover, crosslinking networks hinder the crystal fragmentation during stretching and provide higher strength, resulting in 8.3% higher tensile strength of a 10 wt% EPDM blend than neat POE and almost the same elongation at break. Though excessive crosslinking points offer higher strength, they weaken the elongation at break.

The difference in compatibility at the molecular level can lead to a change of microphase separation structure of thermoplastic polyurethanes blend systems, which will improve their thermal and mechanical properties. In this study, TDI-polyester based TPU was blended with MDI-polyether-based TPU and MDI-polyester based TPU, with different ratios. In the blend system, the obvious reduction of the melting temperature of the high-temperature TDI-polyester based TPU component indicates its hard segments can be mutually integrated with the other component. For TDI-polyester based TPU/MDI-polyether based TPU blends, their similar hard segment ratio and similar chemical structure of the soft segment give the molecular chains of the two components better compatibility. The aggregation structure of the two kinds of chains can rearrange at the molecular level which makes the hard domains mutually integrate to form a new phase separation structure with larger phase region distance. As a result, the yield strength of this blend increased by almost 143% when the elongation at break was only reduced by 12%. In contrast, the other group of blends still partly maintain their respective micro domains, forming a weak interface and leading to a decreased of elongation at break.