No abstract

No abstract

A ball-on-disk tribometer was employed to evaluate the lubrication performance and mechanisms of innovative TiO 2 nano-additive water-based lubricants. Two experimental methods were applied to determine the optimal mass fraction of TiO 2. In the method I, lubricants were added onto the worn disk tracks at a predetermined time interval. In the method II, the disks were immersed in the lubricants continuously during the whole process of tribological tests. The results both indicate that the water-based lubricants can significantly reduce the coefficient of friction (COF). The 0.8 wt% TiO 2 lubricant demonstrates excellent tribological properties including the lowest COF and the strongest wear resistance under all lubrication conditions. The lubrication mechanisms are attributed to the rolling and mending effects of the TiO 2 nanoparticles.

Stir casting is an economical process for the fabrication of aluminum matrix composites. There are many parameters in this process, which affect the final microstructure and mechanical properties of the composites. In this study, micron-sized SiC particles were used as reinforcement to fabricate Al-3 wt% SiC composites at two casting temperatures (680 and 850 °C) and stirring periods (2 and 6 min). Factors of reaction at matrix/ ceramic interface, porosity, ceramic incorporation, and agglomeration of the particles were evaluated by scanning electron microscope (SEM) and high-resolution transition electron microscope (HRTEM) studies. From microstructural characterizations, it is concluded that the shorter stirring period is required for ceramic incorporation to achieve metal/ceramic bonding at the interface. The higher stirring temperature (850 °C) also leads to improved ceramic incorporation. In some cases, shrinkage porosity and intensive formation of Al4C3 at the metal/ceramic interface are also observed. Finally, the mechanical properties of the composites were evaluated, and their relation with the corresponding microstructure and processing parameters of the composites was discussed. AbstractStir casting is an economical process for fabricating aluminium matrix composites. There are

No abstract