No abstract

Zoysiagrass seeds had low germination or lack of germination uniformity under natural condition. To improve the final germination percentage of zoysiagrass seeds, we investigated the methods of proper pre-treatment to enhance germination rate of zoysiagrass. Seeds were subjected to the testa scarification and four types of seed priming methods, namely, hydro priming (distilled water), osmotic priming (polyethylene glycol -0.5 MPa, -1.0 MPa, -2.0 MPa), halo priming (Potassium nitrate 100 mM, 200 mM, 400 mM), and solid matrix priming (seed : microcel-E : distilled water = 4:1:8) with and without 25% KOH treatment in the testa. The scarification improved the germination rate and reduced the germination time. Osmotic priming (PEG -0.5 MPa) with scarification were significantly increased the seed germination rate and decreased MGT, and T 50 . Seed germination rate obtained by osmotic priming (PEG -0.5 MPa) with scarification increased above 60% in comparison with natural condition. Conclusively, scarified and primed zoysiagrass seed germinated more rapidly and uniformly in the study. The present results suggested that PEG priming treatment with KOH treatment prior to sowing could improve germination percentage, and this method makes us establish the early zoysiagrasses in the field.

-This paper proposes active power control and frequency support control schemes of wind turbine generation system by using modified Maximum Power Point Tracking(MPPT) of Permanent Magnet Synchronous Generator(PMSG). Most wind turbine generation system is completely decoupled from the power system and power output control with pitch control. According to the frequency deviation, however, MPPT control can not contribute to the frequency change of the power system due to its active power output control. For solving this, the de-loaded(DL) control scheme is constructed for the frequency support control, which is based on applying the active power output control in the rotor speed control of PMSG. The rotor speed by used in the proposed DL control scheme is increased more than the optimal rotor speed of MPPT, and then this speed improvement increases the saved kinetic energy(KE). In order to show the effectiveness of the proposed control scheme, the case studies have been performed using the PSCAD/EMTDC. The results show that the proposed active power output control scheme(DL control and KE discharge control) works properly and the frequency response ability of the power system can be also improved with the frequency support of wind farm.

No abstract

No abstract