Formation of nanotubular TiO₂ structures with varied surface characteristics for biomaterial applications

Abstract

Nanotubular structures were generated on the surface of titanium c.p. by anodization technique in an aqueous solution of acetic acid (14% v/v) with different sources of fluoride ion (HF, NaF, NH F). The aim of using these three different compounds is to study the effect of the counterion (H , Na and NH4+) on the morphology, wettability and surface free energy of the modified surface. Nanotubes were generated at 10 and 15 V for each anodizing solution. To further improve surface characteristics, the samples were heat-treated at 600°C for 4 h and at 560°C for 3 h. SEM images revealed the formation of nanotubes in all anodizing conditions, while their diameter increased proportionally to the electric potential. X-ray diffraction and micro-Raman spectroscopy results showed the presence of both anatase and rutile phases, with a higher content of rutile in the coatings obtained using NH F and an applied potential of 10 V. The heat-treatment significantly increased the wettability of the anodic coatings, especially for the coating obtained at 15 V with HF, which showed values < 7 degrees of contact angle. Besides, the nanotubes show a decrease in diameter due to the heat treatment, except for the nanotubes formed in NH F. Depending on their surface properties (e.g. low contact angle and high surface free energy), these coatings potentially have great potential in biomedical applications, sensors devices, and catalytic applications among others. © 2018 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 106A: 1341-1354, 2018.

<p>Zn-Incorporated TiO2 Nanotube Surface Improves Osteogenesis Ability Through Influencing Immunomodulatory Function of Macrophages</p>

“…The average diameters of Zn-loaded nanotubes on the surfaces of 5V, 15V and 25V TNT substrates were approximately 30±5 nm, 70±7 nm and 100 ±12 nm, respectively. Similar to previous studies, 43 as the anodization voltage rose, the thickness of the nanotube wall also gradually increased. This phenomenon is explained by the increased voltage enhancing the movement of ions over the oxide layer, so as to increase the wall thickness of TNT.…”

Surface-Dependent Osteoblasts Response to TiO2 Nanotubes of Different Crystallinity

“…The diameter of TNTs depends on the current density as it changes the electrochemical etching rate: the increase in current density results in larger TNTs diameter [25]. In our experimental set-up we employed NH 4 F as fluoride ion source, the conductivity of which (70 mS/cm) is higher in comparison with electrolytes based on NaF (50 mS/cm) and a weak HF acid (17 mS/cm) [38]. It also should be noted that an aqueous electrolyte (used in our study) requires much less processing time and the voltage to form TNTs with the same diameter as the ones generated employing organic electrolyte [25].…”

Decreased <em>Porphyromonas gingivalis</em> adhesion and improved biocompatibility on tetracycline-loaded TiO₂&nbsp;nanotubes: an in vitro study

“…27 As previous studies have reported, anodic oxidation is a controlled and cost-effective technology to form TiO 2 nanoscale structures with tunable morphology that is achieved by adjusting voltage and electrolyte concentrations relating to the procedure. 28,29 Figure 1B shows the SEM images of two layers of the cellular TiO 2 nanotube array. From the superior aspect, the sample was divided into a large amount of homogeneous hexagonal nanoscale cells that each had a diameter of approximately 160 nm, and there were approximately 50 nanopores with a diameter approximately 15 nm in each hexagonal cell.…”