Interferometric Surface Relief Measurements with Subnano/Picometer Height Resolution

Abstract

We present an optical interference system nanoprofiler MNP-1 designed for high-precision noncontact measurement of surface relief with subnanometer resolution (root mean square of measured values), based on partial scanning of interference signal. The paper describes the construction of the measurement system with Linnik interferometer and the algorithm for nanorelief surface reconstruction. Experimental measurement results of silicon sample with profile height of surface structure of one interatomic distance obtained by MNP-1 are shown. It was proposed to use an atomically smooth surface as the reference mirror in the interferometer MNP-1 that allowed us to measure monatomic steps of the presented silicon sample. Monatomic steps of 0.31 nm in height on silicon (111) surface were measured with resolution up to 5 pm.

Interferometric Measurement of Heat Transfer above New Generation Foam Concrete

“…The methods of holographic interferometry open new possibilities for heat transfer but also for the research of physical and mechanical characteristics of strength and deformation of materials [22], [23].…”

Ultrathin Picoscale White Light Interferometer

“…In addition, the inteferometer must be stabilized against various acoustic, mechanical or other noises using active or passive approaches which make these systems large in size with tedious alignment. Although, picoscale resolution has been demonstrated previously with compact laser interferometers scanned via piezo-translation stages [12][13][14] , few works have achieved picoscale resolution and stability with a white light interferometer. Furthermore, to make quantitative measurements, it is essential to balance material dispersion in a white light interferometer along with an unambiguous reference to an absolute zero path difference which is difficult with conventional designs.…”

Increasing the Range of Measurements of Profile Height in the Interference Profilometer

“…Измерения, выполняемые интерференционным профилометром, связаны с регистрацией интерферограмм и последующим вычислением карты высот профиля поверхности, находящейся в зоне измерения микроскопа. В случае если в интерферометре микроскопа используется один источник света, для фазосдвигающей интерферометрии [1][2][3] существует ограничение однозначного определения высоты рельефа. Это связано с тем, что интерференционный сигнал имеет периодический характер изменения интенсивности, поэтому его фаза Φ однозначно определяется в интервале одного периода [4].…”