Microstructural Characteristics Investigation of the Chip-Making Process after Machining

Abstract

Machining as a base technology for the manufacture of precision engineering components has a dominant position. Interaction of machine - tool - work piece has a significant impact on the quality of surface, next to under surface changes of worked material and finally to the total production process. In this work microstructures characteristics of the arising chip are evaluated depending on the defined conditions used for machining. Further basic patterns of the manufacturing process as well as the accompanying effects on the cutting process are clarified. Theory of formation of chip is not nearly closed part of the analytical theory of cutting indicates a possibility of further investigation boundaries of these zones of deformation, the application of mathematical, physical and other methods of examination, verification of modern experimental methods. Thickness of chip was achieved to 50 µm. This micro hardness value was selected to the plastic zones. In area of primary plastic deformation was in range from 256,7 to 264,0 HV 0,1. Area of secondary plastic deformation was higher as primary plastic deformation, it was in range of 289,4 to 357,4 HV 0,1. In plastic deformation area was in range from 261,5 to 278,2 HV 0,1 which is consequence of the action of the outgoing temperature

Hydroxyapatite and Zinc Oxide Based Two-Layer Coating, Deposited on Ti6al4v Substrate

“…It is known that the hybrid organic-inorganic structure initiates pliable bone. Natural polysaccharide alginate (Alg) is widely used for bone tissue engineering [Kuen 2012, Vojtko 2014, also for the stabilization of inorganic nanoparticles [Trandafilovic 2012]. The widespread use of drugs with antimicrobial action has led to the formation of microorganism resistance against antibiotics.…”

Innovation and Recycling of Aluminium Castings in the Form of Plastic Repair Metal Addition Followed by Machining

“…More expensive and rather more often used are the binders that function on the principle of chemical reaction. Their main advantage is that they are nonflammable and can be used under water while they still keep most of the properties of the original material including its machinability [Michna 2005, Rimar 2016, Vojtko 2014, Zaborowski 2007, 2014, Panda 2013, Markulik 2016 Work procedure is simple. At first we prepare the repair area.…”

Technical Diagnostics in the Paper Industry

“…In each of these points was measured vibration velocity (Velocity), vibration acceleration (Acceleration) and envelope acceleration (EnvAcc) depending on the speed. Measurements took place in the value of speed 3000 rpm 8000 rpm and 12,000 rpm [19,20].…”