No abstract

Abstract-We present a method of making low loss split-ring resonators for microfluidic sensing at microwave frequencies using silver coated copper wire. We show that a simple geometric modification and the use of square cross-section wire give greater electric field confinement in the capacitive region of the resonant sensor. We use a combination of theoretical analysis, finite element simulations and empirical measurements to demonstrate the subsequent increases in the sensitivity of these split ring resonators for complex permittivity measurements of some common solvents.

A miniaturized 2.4 GHz re-entrant cavity has been designed, manufactured and tested as a sensor for microfluidic compositional analysis. It has been fully evaluated experimentally with water and common solvents, namely methanol, ethanol, and chloroform, with excellent agreement with the expected behaviour predicted by the Debye model. The sensor’s performance has also been assessed for analysis of segmented flow using water and oil. The samples’ interaction with the electric field in the gap region has been maximized by aligning the sample tube parallel to the electric field in this region, and the small width of the gap (typically 1 mm) result in a highly localised complex permittivity measurement. The re-entrant cavity has simple mechanical geometry, small size, high quality factor, and due to the high concentration of electric field in the gap region, a very small mode volume. These factors combine to result in a highly sensitive, compact sensor for both pure liquids and liquid mixtures in capillary or microfluidic environments.

A microwave microstrip sensor incorporating a split ring resonator is presented in this paper for microsphere detection and dielectric characterization within a microfluidic channel. Split ring resonator (SRR) sensor of three different radii, but with approximately equal gap dimensions to change their sensitivity, were designed and fabricated, of resonance frequencies 2.5, 5.0 and 7.5 GHz. To validate the SRR sensors, two sizes of polystyrene microspheres were tested, of diameters 15 and 25 . Measurements of changes in resonance frequency and insertion loss of the odd SRR mode were related to the dielectric contrast provided by the microspheres and their host solvent, here water. COMSOL Multiphysics was used to model the sensors, and good agreements were found between the simulated and measured results.