In this study, an innovative and high-throughput parallel-single-drop microextraction (Pa-SDME) using the [P6,6,6,14+]2[MnCl42−] magnetic ionic liquid (MIL) as extraction phase is demonstrated, for the first time, in the determination of methylparaben, ethylparaben, propylparaben, bisphenol A, butylparaben, benzophenone and triclocarban from environmental aqueous samples. This experimental setup comprised of a 96-well plate system containing a set of magnetic pins which aided in stabilizing the MIL drops and enabled the simultaneous extraction of up to 96 samples. Using this low-cost experimental apparatus, the sample throughput was lower than 1 min per sample. This novel approach exhibits a number of advantages over classical SDME approaches, particularly in maintaining a stable solvent microdrop and facilitating highthroughput analysis. Experimental conditions were carefully optimized using one-factor-at-a-time and multivariate designs. The optimal conditions employed 5.38 ± 0.55 mg (n = 10) of MIL, a sample volume of 1.5 mL at pH 6, and dilution in 20 μL of acetonitrile. The analytical parameters of merit were determined under the optimized conditions and highly satisfactory results were achieved, with LODs ranging from 1.5 to 3 μg L−1 and coefficients of determination higher than 0.994. Intraday and interday precision ranged from 0.6 to 21.3% (n = 3) and 10.4-20.2% (n = 9), respectively, with analyte relative recovery in three aqueous samples ranging between 63% and 126%.

This paper reports, for the first time, the development of an analytical method employing modified matrix solid-phase dispersion (MSPD) for the extraction of CH3Hg(+) and Hg(2+) species from fish samples. Separation and determination of mercury species were performed by gas chromatography coupled to mass spectrometry (GC/MS). Important MSPD parameters, such as sample mass, type and mass of solid support, concentration of extraction solution (HCl and NaCl), and stirring time, were investigated by the response surface methodology. The derivatization step and the separation of mercury species were also evaluated for the determination by GC/MS. Quantitative recoveries were obtained with 0.2 g of fish sample, 0.5 g of SiO2 as the solid support, 0.5 mol L(-1) NaCl and 4.2 mol L(-1) HCl as the extraction solution, and 1 min stirring time. The MSPD method showed to be suitable for the extraction and determination of mercury species in certified reference materials of dogfish liver (DOLT-3) and dogfish muscle (DORM-2). It had good agreement (about 99%) with the certified values, and the relative standard deviation was lower than 9.5%. The limits of detection were 0.06 and 0.12 μg g(-1), for CH3Hg(+) and Hg(2+), respectively. A matrix effect was observed, and the quantification was carried out by the matrix-matched calibration. The method was applied to tuna fish ( Thunnus thynnus ), angel shark ( Squatina squatina ), and guitarfish ( Rhinobatos percellens ) samples. The results of the mercury speciation by MPSD and GC/MS were compared to the total mercury concentration determined by flow injection cold vapor generation inductively coupled plasma mass spectrometry, after microwave-assisted digestion. Agreement ranged from 102% to 105%.

Clean extracts are essential in LC-MS/MS, since the matrix effect can interfere in the analysis. Alternative materials which can be used as sorbents, such as chitosan in the clean-up step, are cheap and green options. In this study, chitosan from shrimp shell waste was evaluated as a sorbent in the QuEChERS method in order to determine multi-residues of veterinary drugs in different types of milk, i. e., fatty matrices. After optimization, the method showed correlation coefficients above 0.99, LOQs ranged between 1 and 50μgkg and recoveries ranged between 62 and 125%, with RSD<20% for all veterinary drugs in all types of milk under study. The clean-up step which employed chitosan proved to be effective, since it reduced both the matrix effect (from values between -40 and -10% to values from -10 to +10%) and the extract turbidity (up to 95%). When the proposed method was applied to different milk samples, residues of albendazole (49μgkg), sulfamethazine (

This work reports the development of a dispersive liquid-liquid microextraction method for the simultaneous extraction, preconcentration, and derivatization of Hg(2+) and CH3Hg(+) species from water samples for further determination by GC-MS. Some parameters of the proposed method, such as volume and type of disperser and extraction solvent, and Na[B(C6H5)4] concentration were investigated using response surface methodology. Suitable recoveries were obtained using 80 μL C2 Cl4 (as extraction solvent), 1000 μL ethanol (as disperser solvent), and 300 μL 2.1 mmol/L Na[B(C6H5)4] (as derivatizing agent). Accuracy was evaluated in terms of recovery and ranged from 87 to 99% with RSD values <7%. In addition, a certified reference material of water (NIST 1641d) was analyzed and agreed with the certified value about 107% (for Hg(2+)), with RSD values <8.5%. LODs were 0.3 and 0.2 μg/L, with enrichment factors of 112 and 115 for Hg(2+) and CH3Hg(+), respectively. The optimized method was applied for the determination of Hg(2+) and CH3Hg(+) in tap, well, and lake water samples.

This work reports, for the first time, the determination of major and trace elements (Al, As, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, La, Mg, Mn, Mo, Na, Ni, P, Pb, S, Se, Sn, Sr, Ti, Tl, U, V, and Zn) in the fractions of the synthesis of fatty acid methyl esters (FAMEs). These include fresh microalgae, residual biomass, lipid fraction, crude FAMEs, insoluble fraction and purified FAMEs from microalgae Chlorella sp. A microwave-assisted digestion procedure in closed vessels was applied for sample digestion and subsequent element determination by inductively coupled plasma-based techniques. The proposed method was suitable for the multielement determination in FAMEs and its fractions obtained from microalgae. The element concentration was compared with results found in the literature and a careful discussion about the use of residual biomass for different applications was performed.