Objective Distilled liquid smoke (DLS) is a result of coconut processing by-product that not only serves as a natural food preservative but also has a promising therapeutic effect. The healing potential of DLS derived from coconut (Cocos nucifera L) shell was investigated on a traumatic ulcer with the diabetic rat. Materials and Methods DLS was analyzed the component by gas chromatograph mass spectrometry. Diabetic condition was induced by alloxan in 55 male Wistar rats. Ten mm of traumatic ulcer was made along the labial fornix incisive inferior after the diabetic condition was confirmed. Then DLS coconut shell, benzydamine hydrochloride, and sterile distilled water were applied topically for 3, 5, and 7 days. The potential healing was evaluated based on the expression of nuclear factor kappa beta (NFκB) and tumor necrosis factor alpha (TNF-α) on macrophages using immunohistochemical staining and the amount of collagen using Masson Trichome staining. The difference between each group was analyzed using one-way analysis of variance. The least significant difference test is used to determine the significant difference (p < 0.05). Results The major compounds found were phenol (36.6%), 2-methoxyphenol (guaiacol) (25.2%), furfural (17.8%), and 4-ethyl-2-methoxyphenol (3.5%) with 28 other minor constituents. The lowest NFκB and TNF-α expression on macrophage was observed by topical application of DLS derived from coconut shell for 3, 5, and 7 days of treatment. The amount of collagen was increased and indicated by the highest result of DLS compared to others. Conclusion The DLS derived from coconut (Cocos nucifera L) shell was able to improve traumatic ulcer healing in a person with diabetes.

Catalytic upgrading of pyroligneous acid, by-product from slow pyrolysis of woody biomass for char production, was carried out using zirconia-supported iron-oxide catalysts under a steam atmosphere at temperatures ranging from 623 to 723 K, and the effect of ZrO 2 content in the ZrO 2 -FeO X catalysts on catalytic activity and ketone yields was investigated. It was demonstrated that hydroxyacetone and carboxylic acids (acetic and propionic acids) in the pyroligneous acid were converted into aliphatic ketones (acetone and 2-butanone) via a ketonization reaction over the ZrO 2 -FeO X catalyst. However, reaction inhibition by metal impurities in the pyroligneous acid such as potassium (K) and magnesium (Mg) was also observed. These metal impurities could be removed from the pyroligneous acid without changing the organic composition by using an ion-exchange resin. The removal of the metal impurities was effective in increasing the ketone yields. Moreover, as the W/F value (W: amount of catalyst, and F: flow rate of the pyroligneous acid in the feed) increased, the ketone yield increased up to approximately 30 C mol%, and the ketone fraction in the liquid product reached 55 C mol%.

No abstract

This paper reported the method development and validation of a gas chromatography with thermal conductivity detector (GC-TCD) method for the measurement of the gaseous products of hydrodeoxygenation (HDO). The method validation parameters include selectivity, precision (repeatability and reproducibility), accuracy, linearity, limit of detection (LoD), limit of quantitation (LoQ), and robustness. The results showed that the developed method was able to separate the target components (H2, CO2, CH4 and CO) from their mixtures without any special sample treatment. The validated method was selective, precise, accurate, and robust. Application of the developed and validated GC-TCD method to the measurement of by-product components of HDO of bio-oil revealed a good performance with relative standard deviation (RSD) less than 1.0% for all target components, implying that the process of method development and validation provides a trustworthy way of obtaining reliable analytical data.