The growth of gold nanoparticles (NPs) synthesized by sputter deposition on an ionic liquid surface is studied in situ in the bulk phase of the ionic liquids (ILs) 1-butyl-3-methylimidazolium dicyanamide [C(1)C(4)Im][N(CN)(2)], 1-butyl-3-methylimidazolium bis(trifluoromethanesulfonyl)amide [C(1)C(4)Im][Tf(2)N], 1-butyl-3-methylimidazolium tetrafluoroborate [C(1)C(4)Im][BF(4)], 1-butyl-3-methylimidazolium hexafluorophosphate [C(1)C(4)Im][PF(6)] and 1-butyl-3-methylimidazolium triflate [C(1)C(4)Im][TfO]. It is found that primary nanoparticles with a diameter smaller than 2.5 nm are present in the sample immediately after sputtering. Growth of these primary particles proceeds after the end of the sputtering process and stops when the nanoparticles reach a certain size. Depending on the viscosity of the ionic liquid this growth process can proceed several hours to several days. The growth speed is fastest for the least viscous ionic liquid and follows the trend [C(1)C(4)Im][N(CN)(2)] > [C(1)C(4)Im][Tf(2)N] > [C(1)C(4)Im][TfO] > [C(1)C(4)Im][BF(4)] > [C(1)C(4)Im][PF(6)]. It is also found that a higher concentration of sputtered gold results in faster growth of the gold nanoparticles. A discussion on the growth mechanism of sputtered gold NPs is included.

The stability of gold nanoparticles synthesised by sputter deposition has been studied in situ in 1-butyl-3-methylimidazolium ionic liquids with bis(trifluoromethylsulfonyl)imide, tetrafluoroborate, hexafluorophosphate and dicyanamide anions with UV-VIS absorption spectroscopy and transmission electron microscopy. Besides the growth of the gold nanoparticles, two other processes were observed after sputtering, namely aggregation and sedimentation of these nanoparticles. To model the absorption spectra of the sputtered gold nanoparticles, generalized multiparticle Mie calculations were performed. These theoretical calculations confirm the increase in absorbance at longer wavelength for larger aggregates and are in agreement with the experimental observations. It was found that the kinetics of aggregation and sedimentation scale with the viscosity of the ionic liquid. Small amounts of water were found to have a large detrimental influence on the stability of the colloidal suspensions of the gold nanoparticles in ionic liquids. From the large discrepancy between the theoretical and the experimentally observed stability of the NPs, it was concluded that structural forces stabilize the gold nanoparticles. This was also borne out by AFM measurements.

Uranium(VI) oxide has been dissolved in three different ionic liquids functionalized with a carboxyl group: betainium bis[(trifluoromethyl)sulfonyl]imide, 1-(carboxymethyl)-3-methylimidazolium bis[(trifluoromethyl)sulfonyl]imide, and N-(carboxymethyl)-N-methylpyrrolidinium bis[(trifluoromethyl)sulfonyl]imide. The dissolution process results in the formation of uranyl complexes with zwitterionic carboxylate ligands and bis[(trifluoromethyl)sulfonyl]imide (bistriflimide) counterions. An X-ray diffraction study on single crystals of the uranyl complexes revealed that the crystal structure strongly depends on the cationic core appended to the carboxylate groups. The betainium ionic liquid gives a dimeric uranyl complex, the imidazolium ionic liquid a monomeric complex, and the pyrrolidinium ionic liquid a one-dimensional polymeric uranyl complex. Extended X-ray absorption fine structure measurements have been performed on the betainium uranyl complex. The absorption and luminescence spectra of the uranyl betainium complex have been studied in the solid state and dissolved in water, in acetonitrile, and in the ionic liquid betainium bistriflimide. The carboxylate groups remain coordinated to uranyl in acetonitrile and in betainium bistriflimide but not in water.

A series of nitrile-functionalized ionic liquids were found to exhibit temperature-dependent miscibility (thermomorphism) with the lower alcohols. Their coordinating abilities toward cobalt(II) ions were investigated through the dissolution process of cobalt(II) bis(trifluoromethylsulfonyl)imide and were found to depend on the donor abilities of the nitrile group. The crystal structures of the cobalt(II) solvates [Co(C(1)C(1CN)Pyr)(2)(Tf(2)N)(4)] and [Co(C(1)C(2CN)Pyr)(6)][Tf(2)N](8), which were isolated from ionic-liquid solutions, gave an insight into the coordination chemistry of functionalized ionic liquids. Smooth layers of cobalt metal could be obtained by electrodeposition of the cobalt-containing ionic liquids.