BackgroundSuperparamagnetic iron oxide nanoparticles (SPIONs) are the most commonly used negative MRI contrast agent which affect the transverse (T2) relaxation time. The aim of the present study was to investigate the impact of various polymeric coatings on the performance of magnetite nanoparticles as MRI contrast agents.MethodsFerrofluids based on magnetite (Fe3O4) nanoparticles (SPIONs) were synthesized via chemical co-precipitation method and coated with different biocompatible polymer coatings including mPEG-PCL, chitosan and dextran.ResultsThe bonding status of different polymers on the surface of the magnetite nanoparticles was confirmed by the Fourier transform infrared spectroscopy (FT-IR) and thermogravimetric analysis (TGA). The vibrating sample magnetometer (VSM) analysis confirmed the superparamagnetic behavior of all synthesized nanoparticles. The field–emission scanning electron microscopy (FE-SEM) indicated the formation of quasi-spherical nanostructures with the final average particle size of 12–55 nm depending on the type of polymer coating, and X-ray diffraction (XRD) determined inverse spinel structure of magnetite nanoparticles. The ferrofluids demonstrated sufficient colloidal stability in deionized water with the zeta potentials of −24.2, −16.9, +31.6 and −21 mV for the naked SPIONs, and for dextran, chitosan and mPEG-PCL coated SPIONs, respectively. Finally, the magnetic relaxivities of water based ferrofluids were measured on a 1.5T clinical MRI instrument. The r2/r1 value was calculated to be 17.21, 19.42 and 20.71 for the dextran, chitosan and mPEG-PCL coated SPIONs, respectively.ConclusionsThe findings demonstrated that the value of r2/r1 ratio of mPEG-PCL modified SPIONs is higher than that of some commercial contrast agents. Therefore, it can be considered as a promising candidate for T2 MRI contrast agent.

Using non-equilibrium molecular dynamics (NEMD) simulation, we study thermal properties of the so-called nanoporous graphene (NPG) sheet which contains a series of nanoporous in an ordered way and was synthesized recently (Science 360 (2018), 199).The dependence of thermal conductivity on sample size, edge chirality, and porosity concentration are investigated. Our results indicate that the thermal conductivity of NPG is about two orders smaller compared with of pristine graphene. Therefore this sheet can be used as a thermoelectric material. Also, the porosity concentration helps us to tune the thermal conductivity. Moreover, the results show that the thermal conductivity increases with growing sample length due to ballistic transport. On the other hand, along the armchair direction, the thermal conductivity is larger than zigzag direction. We also examined the thermal properties of the interface of NPG and graphene. The temperature drops significantly through the interface leading to the thermal resistance. The thermal resistance changes with imposed heat flux direction, and this difference cause significantly large thermal rectification factor, and heat current prefers one direction to another. Besides, to investigate those quantities fundamentally, we study the phonon density of states and scattering of them.2

Introduction: Expansion of efficacious theranostic systems is of pivotal significance for medicine and human healthcare. Magnetic nanoparticles (MNPs) are known as drug delivery system and magnetic resonance imaging (MRI) contrast agent. MNPs as drug carriers have attracted significant attention because of the delivery of drugs loaded onto MNPs to solid tumors, maintaining them in the target site by an external electromagnetic field, and subsequently releasing drugs in a controlled manner. On the other hand, it is believed that MNPs possess high potential as MRI contrast agents. The aim of this work was to payload curcumin into dextran coated MNPs and investigate their potential as theranostic systems for controlled drug delivery and MRI imaging. Methods: MNPs were synthesized as a core and coated with dextran as polymeric shell to provide steric stabilization. Curcumin as anticancer drug was selected to be loaded into NPs. To characterize the synthesized NPs, various techniques (e.g., DLS, FESEM, FT-IR, XRD, and VSM) were utilized. In vitro drug release of curcumin was evaluated at 37˚C at the pH value of 5.4 and 7.4.The feasibility of employment of dextran coated MNPs as MRI contrast agents were also studied. Results: Formulations prepared from dextran coated MNPs showed high loading (13%) and encapsulation efficiency (95%). In vitro release study performed in the phosphate-buffered saline (PBS, pH= 7.4, 5.4) revealed that the dextran coated MNPs possess sustained release behavior at least for 4 days with the high extent of drug release in acidic media. Vibrating sample magnetometer (VSM) analysis proved the superparamagnetic properties of the dextran coated MNPs with relatively high-magnetization value indicating that they were sufficiently sensitive to external magnetic fields as magnetic drug carriers. Furthermore, dextran coated MNPs exhibited high potential as T2 contrast agents for MRI. Conclusion: Based on our findings, we propose the dextran coated MNPs as promising nanosystem for the delivery of various drugs such as curcumin and MRI contrast agent.

We report peculiar charge and spin transport properties in S-shaped silicene junctions with the Kane-Mele tight-binding model. In this work, we investigate the effects of electric and exchange fields on the charge and spin transport properties. Our results show that by applying a perpendicular electric field, metal-semiconductor and also semimetal-semiconductor phase transitions occur in our systems. Furthermore, full spin current can be obtained in the structures, so the half-metallic states are observable. Our results enable us to control charge and spin currents and provide new opportunities and applications in silicene-based electronics, optoelectronics, and spintronics.

The intercalated water into nanopores exhibits anomalous properties such as an ultralow dielectric constant. Multiscale modeling and simulations are used to investigate the dielectric properties of various crystalline two-dimensional ices and bulk ices. Although the structural properties of two-dimensional (2D) ices have been extensively studied, much less is known about their electronic and optical properties. First, by using density functional theory and density functional perturbation theory (DFPT), we calculate the key electronic, optical, and dielectric properties of 2D ices. Performing DFPT calculations, both the ionic and electronic contributions of the dielectric constant are computed. The in-plane electronic dielectric constant is found to be larger than the out-of-plane dielectric constant for all the studied 2D ices. The in-plane dielectric constant of the electronic response (ε el ) is found to be isotropic for all the studied ices. Second, we determined the dipolar dielectric constant of 2D ices using molecular dynamics simulations at finite temperature. The total out-of-plane dielectric constant is found to be larger than 2 for all the studied 2D ices. Within the framework of the random-phase approximation, the absorption energy ranges for 2D ices are found to be in the ultraviolet spectra. For comparison purposes, we also elucidate the electronic, dielectric, and optical properties of four crystalline ices (ice VIII, ice XI, ice Ic, and ice Ih) and bulk water.