High mobility III-V substrates with high-k oxides are required for device scaling without loss of channel mobility. Interest has focused on the self-cleaning effect on selected III-V substrates during atomic layer deposition of Al2O3. A thin (∼1 nm) Al2O3 interface control layer is deposited on In0.53Ga0.47As prior to HfO2 growth, providing the benefit of self-cleaning and improving the interface quality by reducing interface state defect densities by ∼50% while maintaining scaling trends. Significant reductions in leakage current density and increased breakdown voltage are found, indicative of a band structure improvement due to the reduction/removal of the In0.53Ga0.47As native oxides.

The atomic layer deposition of high dielectric constant oxides like HfO2 on III-V substrates such as In0.53Ga0.47As leads to a poor interface, with the growth of In0.53Ga0.47As native oxides regardless of the surface pretreatment and passivation method. The presence of the native oxides leads to poor gate leakage current characteristics due to the low band gap of the native oxides and the presence of potential wells at the interface. In addition, the poor quality of this interface leads to very large interface state defect densities, which are detrimental to metal-oxide-semiconductor-based device performance. A wide band gap interlayer replacing the native oxide layer would remove the potential wells and provide a larger barrier to conduction. It may also assist in the improvement of the interface quality, but the problem remains as to how this native oxide interlayer cannot only be removed but prevented from regrowing. In this regard, the authors present electrical results showing that the atomic layer deposition (ALD) growth of a thin (∼1 nm) Al2O3 layer before the ALD growth of HfO2 causes a removal/reduction of the native oxides on the surface by a self-cleaning process without subsequent regrowth of the native oxides. As a result, there are significant improvements in gate leakage current densities, and significant improvements in the frequency dispersion of capacitance versus gate voltage, even when a defective In0.53Ga0.47As epitaxial layer on an InP substrate is employed. Measurements at different temperatures confirm that the frequency dispersion is mainly due to interface state defect responses and another weakly temperature dependent mechanism such as border traps, after accounting for the effects of nonideal In0.53Ga0.47As epitaxial layer growth defects where applicable.

We report on experimental observations of room temperature low frequency capacitance-voltage (CV) behaviour in metal oxide semiconductor (MOS) capacitors incorporating high dielectric constant (high-k) gate oxides, measured at ac signal frequencies (2 kHz to 1 MHz), where a low frequency response is not typically expected for Si or GaAs MOS devices. An analysis of the inversion regions of the CV characteristics as a function of area and ac signal frequency for both n and p doped Si and GaAs substrates indicates that the source of the low frequency CV response is an inversion of the semiconductor/high-k interface in the peripheral regions outside the area defined by the metal gate electrode, which is caused by charge in the high-k oxide and/or residual charge on the high-k oxide surface. This effect is reported for MOS capacitors incorporating either MgO or GdSiOx as the high-k layers on Si and also for Al2O3 layers on GaAs(111B). In the case of NiSi/MgO/Si structures, a low frequency CV response is observed on the p-type devices, but is absent in the n-type devices, consistent with positive charge (>8 × 1010 cm−2) on the MgO oxide surface. In the case of the TiN/GdSiOx/Si structures, the peripheral inversion effect is observed for n-type devices, in this case confirmed by the absence of such effects on the p-type devices. Finally, for the case of Au/Ni/Al2O3/GaAs(111B) structures, a low-frequency CV response is observed for n-type devices only, indicating that negative charge (>3 × 1012 cm−2) on the surface or in the bulk of the oxide is responsible for the peripheral inversion effect.

Gallium-Nitride technology is known for its high power density and power amplifier designs, but is also very well suited to realize robust receiver components. This paper presents the design and measurement of a robust AlGaN/GaN Low Noise Amplifier and Transmit/Receive Switch MMIC. Two versions of both MMICs have been designed in the Alcatel-Thales III-V lab AlGaN/GaN microstrip technology. One chipset version operates at X-band and the second also shows wideband performance. Input power handling of >46 dBm for the switch and >41 dBm for the LNA have been measured.