No abstract

The impact of various substrates and zinc oxide (ZnO) ultra thin seed layers prepared by atomic layer deposition on the geometric morphology of subsequent ZnO nanowire arrays (NWs) fabricated by the hydrothermal method was investigated. The investigated substrates included B-doped ZnO films, indium tin oxide films, single crystal silicon (111), and glass sheets. Scanning electron microscopy and X-ray diffraction measurements revealed that the geometry and aligment of the NWs were controlled by surface topography of the substrates and thickness of the ZnO seed layers, respectively. According to atomic force microscopy data, we suggest that the substrate, fluctuate amplitude and fluctuate frequency of roughness on ZnO seed layers have a great impact on the alignment of the resulting NWs, whereas the influence of the seed layers' texture was negligible.

No abstract

In this manuscript, we reported that the room temperature ferromagnetism was observed in (Zn0.70, Al0.30)O film, which was fabricated by a novel physical method (pulse laser deposition (PLD)). The film was deposited from (Zn0.80, Al0.20)O ceramic target onto quartz (110) substrate by PLD at 400 degrees C under an oxygen partial pressure of 10(-4) torr. TEM result shows ZnO NCs with diameter of 4-5 nm and they are quite uniformly embedded into amorphous ZnO-Al2O3 phase. The SAED shows clearly that ZnO NCs possess polycrystalline structure. The SQUID measurement shows that the film has room temperature ferromagnetism (saturation magnetization = 3.6 emu/cm3) with Curie temperature above 300 K. The magnitude of magnetic moment of the films can be changed by tuning ZnO NCs size. Both oxygen partial pressure and film thickness studies show that the origin of ferromagnetism is possibly related to the oxygen defects at the surface of ZnO NCs.