Low-density electrical 16S rRNA specific oligonucleotide microarrays and an automated analysis system have been developed for the identification and quantitation of pathogens. The pathogens are Escherichia coli, Pseudomonas aeruginosa, Enterococcus faecalis, Staphylococcus aureus, and Staphylococcus epidermidis, which are typically involved in urinary tract infections. Interdigitated gold array electrodes (IDA-electrodes), which have structures in the nanometer range, have been used for very sensitive analysis. Thiol-modified oligonucleotides are immobilized on the gold IDA as capture probes. They mediate the specific recognition of the target 16S rRNA by hybridization. Additionally three unlabeled oligonucleotides are hybridized in close proximity to the capturing site. They are supporting molecules, because they improve the RNA hybridization at the capturing site. A biotin labeled detector oligonucleotide is also allowed to hybridize to the captured RNA sequence. The biotin labels enable the binding of avidin alkaline phophatase conjugates. The phosphatase liberates the electrochemical mediator p-aminophenol from its electrically inactive phosphate derivative. The electrical signals were generated by amperometric redox cycling and detected by a unique multipotentiostat. The read out signals of the microarray are position specific current and change over time in proportion to the analyte concentration. If two additional biotins are introduced into the affinity binding complex via the supporting oligonucleotides, the sensitivity of the assays increase more than 60%. The limit of detection of Escherichia coli total RNA has been determined to be 0.5 ng/microL. The control of fluidics for variable assay formats as well as the multichannel electrical read out and data handling have all been fully automated. The fast and easy procedure does not require any amplification of the targeted nucleic acids by PCR.

A fully electrical array for voltammetric detection of redox molecules produced by enzyme-labeled affinity binding complexes is shown. The electronic detection is based on ultramicroelectrode arrays manufactured in silicon technology. The 200-microm circular array positions have 800-nm-wide interdigitated gold ultramicroelectrodes embedded in silicon dioxide. Immobilization of oligonucleotide capture probes onto the gold electrodes surfaces is accomplished via thiol-gold self-assembling. Spatial separation of probes at different array positions is controlled by polymeric rings around each array position. The affinity bound complexes are labeled with alkaline phosphatase, which converts the electrochemically inactive substrate 4-aminophenyl phosphate into the active 4-hydroxyaniline (HA). The nanoscaled electrodes are used to perform a sensitive detection of enzyme activity by signal enhancing redox recycling of HA resulting in local and position-specific current signals. Multiplexing and serial readout is realized using a CMOS ASIC module and a computer-controlled multichannel potentiostat. The principle of the silicon-based electrical biochip array is shown for different experimental setups and for the detection of virus DNA in real unpurified multiplex PCR samples. The fast and quantitative electronic multicomponent analysis for all kinds of affinity assays is robust and particle tolerant.

A novel innovative approach towards a marketable lab-on-chip system for point-of-care in vitro diagnostics is reported. In a consortium of seven Fraunhofer Institutes a lab-on-chip system called "Fraunhofer ivD-platform" has been established which opens up the possibility for an on-site analysis at low costs. The system features a high degree of modularity and integration. Modularity allows the adaption of common and established assay types of various formats. Integration lets the system move from the laboratory to the point-of-need. By making use of the microarray format the lab-on-chip system also addresses new trends in biomedicine. Research topics such as personalized medicine or companion diagnostics show that multiparameter analyses are an added value for diagnostics, therapy as well as therapy control. These goals are addressed with a low-cost and self-contained cartridge, since reagents, microfluidic actuators and various sensors are integrated within the cartridge. In combination with a fully automated instrumentation (read-out and processing unit) a diagnostic assay can be performed in about 15 min. Via a user-friendly interface the read-out unit itself performs the assay protocol, data acquisition and data analysis. So far, example assays for nucleic acids (detection of different pathogens) and protein markers (such as CRP and PSA) have been established using an electrochemical read-out based on redoxcycling or an optical read-out based on total internal reflectance fluorescence (TIRF). It could be shown that the assay performance within the cartridge is similar to that found for the same assay in a microtiter plate. Furthermore, recent developments are the integration of sample preparation and polymerase chain reaction (PCR) on-chip. Hence, the instrument is capable of providing heating-and-cooling cycles necessary for DNA-amplification. In addition to scientific aspects also the production of such a lab-on-chip system was part of the development since this heavily affects the success of a later market launch. In summary, the Fraunhofer ivD-platform covers the whole value chain ranging from microfluidics, material and polymer sciences, assay and sensor development to the production and assembly design. In this consortium the gap between diagnostic needs and available technologies can be closed.

A silicon chip-based electric detector coupled to bead-based sandwich hybridization (BBSH) is presented as an approach to perform rapid analysis of specific nucleic acids. A microfluidic platform incorporating paramagnetic beads with immobilized capture probes is used for the bio-recognition steps. The protocol involves simultaneous sandwich hybridization of a single-stranded nucleic acid target with the capture probe on the beads and with a detection probe in the reaction solution, followed by enzyme labeling of the detection probe, enzymatic reaction, and finally, potentiometric measurement of the enzyme product at the chip surface. Anti-DIG-alkaline phosphatase conjugate was used for the enzyme labeling of the DIG-labeled detection probe. p-Aminophenol phosphate (pAPP) was used as a substrate. The enzyme reaction product, p-aminophenol (pAP), is oxidized at the anode of the chip to quinoneimine that is reduced back to pAP at the cathode. The cycling oxidation and reduction of these compounds result in a current producing a characteristic signal that can be related to the concentration of the analyte. The performance of the different steps in the assay was characterized using in vitro synthesized RNA oligonucleotides and then the instrument was used for analysis of 16S rRNA in Escherichia coli extract. The assay time depends on the sensitivity required. Artificial RNA target and 16S rRNA, in amounts ranging from 10(11) to 10(10) molecules, were assayed within 25 min and 4 h, respectively.

Based on electrical biochips made in Si-technology cost effective portable devices have been constructed for field applications and point of care diagnosis. These miniaturized amperometric biosensor devices enable the evaluation of biomolecular interactions by measuring the redox recycling of ELISA products, as well as the electrical monitoring of metabolites. The highly sensitive redox recycling is facilitated by interdigitated ultramicroelectrodes of high spatial resolution. The application of these electrical biochips as DNA microarrays for the molecular diagnosis of viral infections demonstrates the measurement procedure. Self-assembling of capture oligonucleotides via thiol-gold coupling has been used to construct the DNA interface on-chip. Another application for this electrical detection principle is continuous measuring with bead-based biosensors. Here, paramagnetic nanoparticles are used as carriers of the bioanalytical interface in ELISA format. A Si-micromachined glucose sensor for continuous monitoring in interstitial fluid ex vivo shows the flexibility of the electrical platform. Here the novel approach is a pore membrane in micrometer-dimensions acting as a diffusion barrier. The electrochemical detection takes place in a cavity containing glucose oxidase and a Pt-electrode surface. The common hydrogen peroxide detection, together with Si technology, enable precise differential measurements using a second cavity.