The calcium looping process is a fast-developing post-combustion CO 2 capture technology in which combustion flue gases are treated in two interconnected fluidized beds. CO 2 is absorbed from the flue gases with calcium oxide in the carbonator operating at 650 ºC. The resulting CaCO 3 product is regenerated into CaO and CO 2 in the calciner producing a pure stream of CO 2. In order to produce a suitable gas stream for CO 2 compression, oxy-combustion of a fuel, such as coal, is required to keep the temperature of the calciner within the optimal operation range of 880-920°C. Studies have shown that the calcium looping process CO 2 capture efficiencies are between 70 % and 97 %. The calciner reactor is a critical component in the calcium looping process. The operation of the calciner determines the purity of gases entering the CO 2 compression. The optimal design of the calciner will lower the expenses of the calcium looping process significantly. Achieving full calcination at the lowest possible temperature reduces the cost of oxygen and fuel consumption. In this work, a 1.7 MW pilot plant calciner was studied with two modeling approaches: 3-D calciner model and 1-D process model. The 3-D model solves fundamental balance equations for a fluidized bed reactor operating under steady-state condition by applying the control volume method. In addition to the balance equations, semiempirical models are used to describe chemical reactions, solid entrainment and heat transfer to reduce computation effort. The input values of the 3-D-model were adjusted based on the 1-D-model results, in order to model the behavior of the carbonator reactor realistically. Both models indicated that the calcination is very fast in oxy-fuel conditions when the appropriate temperature conditions are met. The 3-D model was used to study the sulfur capture mechanisms in the oxy-fired calciner. As expected, very high sulfur capture efficiency was achieved. After confirming that the 1-D model with simplified descriptions for the sorbent reactions produces similar results to the more detailed 3-D model, the 1-D model was used to simulate calcium looping process with different recirculation ratios to find an optimal area where the fuel consumption is low and the capture efficiency is sufficiently high. It was confirmed that a large fraction of the solids can be recirculated to both reactors to achieve savings in fuel and oxygen consumption before the capture efficiency is affected in the pilot unit. With low recirculation ratios the temperature difference between the reactors becomes too low for the cyclic carbonation and calcination. As a general observation, the small particle size creates high solid fluxes in the calcium looping process that should be taken into account in the design of the system.
a b s t r a c tCalcium looping is an emerging technology for post-combustion carbon dioxide capture and storage in development. In this study, a 1-dimensional dynamical model for the calcium looping process was developed. The model was tested against a laboratory scale 30 kW test rig at INCAR-CSIC, Spain. The study concentrated on steady-state simulations of the carbonator reactor. Capture efficiency and reactor temperature profile were compared against experimental data. First results showed good agreement between the experimental observations and simulations.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.