Formation, adhesion, and accumulation of ice, snow, frost, glaze, rime, or their mixtures can cause severe problems for solar panels, wind turbines, aircrafts, heat pumps, power lines, telecommunication equipment, and submarines. These problems can decrease efficiency in power generation, increase energy consumption, result in mechanical and/or electrical failure, and generate safety hazards. To address these issues, the fundamentals of interfaces between liquids and surfaces at low temperatures have been extensively studied. This has lead to development of so called "icephobic" surfaces, which possess a number of overlapping, yet distinctive, characteristics from superhydrophobic surfaces. Less attention has been given to distinguishing differences between formation and adhesion of ice, snow, glaze, rime, and frost or to developing a clear definition for icephobic, or more correctly pagophobic, surfaces. In this review, we strive to clarify these differences and distinctions, while providing a comprehensive definition of icephobicity. We classify different canonical families of icephobic (pagophobic) surfaces providing a review of those with potential for scalable and robust development.

The condensing effect of cholesterol on fluid bilayers of 1,2-dipalmitoyl-sn-glycero-3-phosphocholine has been compared with that of dihydrocholesterol and coprostanol by means of nearest-neighbor recognition measurements. Whereas dihydrocholesterol exhibits a condensing power that is equivalent to that of cholesterol, the action of coprostanol is significantly weaker. These results provide strong support for a template mechanism of condensation and argue against an umbrella mechanism.

No abstract

No abstract

The use of organic polymeric membranes to separate gaseous mixtures provides an attractive alternative to other methods such as selective adsorption and cryogenic distillation. The primary advantages of membrane-based separations are their relative energy efficiency and lower costs. Because the flux of a gas across a membrane is inversely proportional to the membrane's thickness, this method relies on fabricating membranes that are as thin as possible. However, as researchers have tried to produce "hyperthin" membranes (less than 100 nm), these membranes often form defects and lose their permeation selectivity. In this Account, we review some of the progress in our laboratories at Lehigh University to create hyperthin membranes with high permeation selectivities. We focus special attention on gaseous permeants that are relevant for the production of clean energy (H2 and CO2 formed from CH4) and the reduction of global warming (CO2 and N2, the major components of flue gas). Our studies make extensive use of Langmuir-Blodgett (LB) methods and porous surfactants derived from calix[6]arenes. We specially designed each surfactant to form cohesive monolayers and multilayers, and we introduced a "gluing" technique, where we cross-link porous surfactants containing quaternary ammonium groups ionically with polymeric counterions. Using ellipsometry, atomic force microscopy, X-ray photoelectron spectroscopy, monolayer isotherm, surface viscosity, and permeation measurements, we have characterized these hyperthin films. While molecular sieving appears to make a significant contribution to the permeation selectivity of some of these membranes, solution-diffusion pathways predominate. We also describe initial studies in which we formed hyperthin films from poly(ethylene glycol)-based polyelectrolytes using layer-by-layer deposition (LbL) methods. We have found remarkably high H2/CO2 and CO2/N2 permeation selectivities with these LB- and LbL-based hyperthin membranes. These results suggest that such materials may lead the way to materials that researchers can exploit to purify hydrogen produced from CH4 and to capture CO2 from flue gas.