Dielectric impedance measurements as well as transient current–voltage (I–V) characteristics under conditions of forward and reverse bias are reported in aluminum/porous silicon (PS)∕p-cSi structures at different temperatures. Under reverse bias conditions, the electrical conduction of the structures can be modeled by a simple equivalent circuit of two parallel RC networks in series combination, representing a bulk and a junction region. The bulk conduction is ohmic. From the detailed analysis of the PS/cSi junction, the carrier concentration NA and the depletion layer width W are evaluated at each temperature. The elapsed time t0 from the onset of the square pulse, at which the transition from the dominant bulk resistance to junction conduction takes place, is a function of temperature. As the temperature decreases, conduction due to bulk resistance dominates over junction conduction. On the other, hand forward conduction is dominated from the bulk. Two conduction mechanisms are present. As the time proceeds, Poole–Frenkel conduction follows an ohmic conduction. The time after the onset of the square voltage pulse, at which this turnover takes place, is a function of temperature.
Thermal sensors are mainly based on the selective heating of specific areas, which in most cases is a critical feature for both the operation and the performance of the thermal device. In this work, we evaluate the thermoelectrical response of two graphitic materials, namely (a) a commercial 2.4%wt graphene–ethyl cellulose dispersion in cycloxehanone and terpineol (G) and (b) a custom functionalized reduced graphene oxide (f-rGO) ink in the range of −40 to 100 °C. Both inks were printed on a flexible polyimide substrate and the Thermal Coefficients of Resistance (TCR) were extracted as TCRG = −1.05 × 10−3 °C−1 (R2 = 0.9938) and TCRf-rGO = −3.86 × 10−3 °C−1 (R2 = 0.9967). Afterward, the inkjet-printed devices were evaluated as microheaters, in order to exploit their advantage for cost-effective production with minimal material waste. f-rGO and G printed heaters reached a maximum temperature of 97.5 °C at 242 mW and 89.9 °C at 314 mW, respectively, applied by a constant current source and monitored by an infrared camera. Repeatability experiments were conducted, highlighting the high robustness in long-term use. The power–temperature behavior was extracted by self-heating experiments to demonstrate the ability of the devices to serve as heaters. Both static and dynamic evaluation were performed in order to study the device behaviors and extract the corresponding parameters. After all the experimental processes, the resistance of the samples was again evaluated and found to differ less than 13% from the initial value. In this work, fabrication via inkjet printing and demonstration of efficient and stable microheaters utilizing a custom ink (f-rGO) and a commercial graphene ink are presented. This approach is suitable for fabricating selectively heated geometries on non-planar substrate with high repeatability and endurance in heat cycles.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.