Ideally, implants should inhibit nonspecific protein adsorption, bacterial adhesion, and at the same time, depending on the final application be selective toward cellular adhesion and spreading for all or only selected cell types. Poly(L-lysine)-grafted-poly(ethylene glycol) (PLL-g-PEG) polymers have been shown to adsorb from aqueous solution onto negatively charged metal oxide surfaces, reducing protein adsorption as well as fibroblast, osteoblast and epithelial cell adhesion significantly. PLL-g-PEG can be functionalized with bioligands such as RGD (Arg-Gly-Asp), which then restores host cell adhesion, but the surface remains resistant to nonspecific protein adsorption. Previously, it was also shown that both nonfunctionalized PLL-g-PEG and RGD-peptide functionalized PLL-g-PEG reduced the adhesion of Staphylococcus aureus to titanium (Ti) surfaces. The present study looked at the effect of other implant associated infection relevant bacteria, Staphylococcus epidermidis, Streptococcus mutans and Pseudomonas aeruginosa towards the same surface chemistries. The different surfaces were exposed to the bacteria for 1-24 h, and bacteria surface density was evaluated using scanning electron microscopy (SEM) and fluorescence light microscopy (FM). The adhesion of all bacteria strains tested was reduced on Ti surfaces coated with PLL-g-PEG compared to uncoated Ti surfaces even in the presence of RGD. The percentage reduction in bacterial adhesion over the 24-h culture time investigated was 88%-98%, depending on the bacteria type. Therefore, coating surfaces with PLL-g-PEG/PEG-RGD allows cells such as fibroblasts and osteoblasts to attach but not bacteria, resulting in a selective biointeractive pattern that may be useful on medical implants.

The influence of lateral ligand mobility on cell attachment and receptor clustering has previously been explored for membrane-anchored molecules involved in cell-cell adhesion. In this study, we considered instead a cell binding motif from the extracellular matrix. Even though the lateral mobility of extracellular matrix ligands in membranes does not occur in vivo, we believe it is of interest for cell engineering in vitro. As is the case for cell-cell adhesion molecules, lateral mobility of extracellular matrix ligands could influence cell attachment and, subsequently, cell behavior in cell culture. In this paper, the accessibility and functionality of extracellular matrix ligands presented at surfaces were evaluated for the conditions of laterally mobile versus non-mobile ligands by studying ligand-antibody binding events and early cell attachment as a function of ligand concentration. We compare the initial attachment of rat-derived adult hippocampal progenitor (AHP) cells on laterally mobile, supported phospholipid bilayer membranes to non-mobile, poly-L-lysine-grafted-poly(ethylene glycol) (PLL-g-PEG) polymer films functionalized with a range of laminin-derived IKVAV-containing peptide densities. To this end, synthesis of a new PLL-g-PEG/PEG-IKVAV polymer is described. The characterization of available IKVAV peptides on both surface presentations schemes was explored by studying the mass uptake of anti-IKVAV antibodies using a combination of the surface-sensitive techniques quartz crystal microbalance with dissipation monitoring, surface plasmon resonance spectroscopy, and optical waveguide lightmode spectroscopy. IKVAV-containing peptides presented on laterally mobile, supported phospholipid bilayers and non-mobile PLL-g-PEG were recognized by the anti-IKVAV antibody in a dose-dependent manner, indicating that the amount of available IKVAV ligands increases proportionally with ligand density over the concentrations tested. Attachment of AHP cells to IKVAV-functionalized PLL-g-PEG and supported phospholipid bilayers followed a sigmoidal dependence on peptide concentration, with a critical concentration of approximately 3 pmol/cm2 IKVAV ligands required to support initial AHP cell attachment for both surface modifications. There appeared to be little influence of IKVAV peptide mobility on the initial attachment of AHP cells. Although the spread in the cell attachment data was larger for the PLL-g-PEG surface modification, this was reduced when observed after 24 h, indicating that the cells might need longer times to establish attachment strengths equivalent to those observed on peptide-functionalized supported lipid bilayers. The present study is a step toward understanding the influence of extracellular-matrix-derived ligand mobility on cell fate. Further analysis should focus on the systematic tuning of lateral ligand diffusion, as well as a comparison between the response of non-spreading cells (i.e., AHPs), versus spreading cells (i.e., fibroblasts).

We describe an experimental procedure to mimic the formation of long (over 40 residues) co-oligopetide sequences in many identical copies which may have occurred in the prebiotic molecular evolution. The basic hypothesis is that chain formation is based on the stepwise fragment condensation of randomly generated short oligopeptides, whereby the elongation takes place under the contingent environmental constraints (solubility, pH, salinity), which eliminate most of the products, and thus determine the selection towards one particular small set of chains. The present work aims at verifying the validity of this scheme. In order to do so, we utilize a classic synthetic procedure based on the Merrifield solid-phase synthesis of peptides for the synthesis of randomly produced peptides as well as for their stepwise fragment condensation. Thus, starting from a library of peptides with n=10, the first condensation step produces a library of 16 peptides with 20 residues each (n=20), of which only four remain water-soluble and, therefore, capable to undergo the next fragment condensation step. This gives rise to 16 peptides with n=30, out of which twelve precipitate out under the chosen pH and buffer conditions and are eliminated. Finally, a 44-residue-long water-soluble de novo protein is obtained. This has no homologies or similarities with extant proteins, and, based on circular dichroism (CD), it assumes a stable three-dimensional folding. In agreement with CD data, molecular-modelling simulations suggest an helical fold for the protein with poor, if any, structural homology with known proteins. The implication of this procedure as a general mechanism for the etiology of de novo macromolecular sequences and globular proteins in the origin of life is briefly discussed.