No abstract

Objective: The objective of the study was to develop floating in situ gel formulations of Ciprofloxacin that has a narrow absorption window and mainly absorbed in the proximal areas of GIT. These formulations increases the targeted action on bacteria for a longer time that can be used in the treatment of Helicobacter pylori (H. pylori) infections and urinary tract infections.Methods: In situ gel formulations were prepared by varying concentrations of sodium alginate as in situ gel forming bio-degradable polymer and calcium carbonate as a cross-linking agent. The formulations were evaluated for Physical appearance, pH, in vitro drug release, viscosity, in vitro floating behaviour, in vitro gelling capacity and drug content. FTIR was conducted for Ciprofloxacin, excipients used and optimized formulation.Results: All the formulations showed an optimum viscosity that will allow ease of administration and swallowing. Floating lag time of all formulations was between 32-70 seconds and floated for>12 h. The in vitro gelling capacity increased with increasing the polymer and gelling agent concentrations. Increase in polymer concentration decreased the rate and extent of the drug release. Among all the formulations, F4 containing 4% w/v of sodium alginate and 4% w/v of calcium carbonate showed sustained in vitro drug release (95.6%) over an extended period of 12 h. FTIR studies revealed no interaction between drug and excipients used. Drug release from the formulations followed First order kinetics with Fickian diffusion.Conclusion: Ciprofloxacin was successfully formulated as a pH-triggered floating in situ gelling system using sodium alginate.

No abstract

Objective: The main objective of this study was to investigate the release pattern of a poorly water-soluble drug quercetin (QU) by fabricating its cyclodextrin nanosponges. Methods: Characterization of the original QU powder and QU-loaded nanosponges was carried out by the Fourier-transformed infrared (FTIR) spectroscopy, transmission electron microscopy (TEM), and dissolution tester. The drug release pattern was subjected to various kinetic models. Results: FTIR studies confirmed the formation of inclusion complex of drug. The particle size analysis revealed that the average particle size measured by laser light scattering method is around 400–420 nm with low polydispersity index. The particle size distribution is unimodal and having a narrow range. A sufficiently high zeta potential indicates that the complexes would be stable and the tendency to agglomerate would be miniscule. TEM image revealed the porous nature of nanosponges. The dissolution of the QU nanosponges was significantly higher compared with the pure drug. Conclusion: From the kinetic study, it is apparent that the regression coefficient value closer to unity in case of Korsmeyer-Peppas model indicates that the drug release exponentially to the elapsed time. n value obtained from the Korsmeyer-Peppas plots, i.e., 0.9911 indicating non-Fickian (anomalous) transport ; thus, it projected that delivered its active ingredient by coupled diffusion and erosion.

In the modern era of drug delivery, microsponges have their own tremendous properties of porous nature, due to this porous nature they have a capacity to entrap active drug and acts as a drug carrier because of this entrapment controlling the drug release and targeting the drug to a particular site is possible. Initially, this microsponge drug delivery has been used for topical route and later on oral route, recently, researches focused on the pulmonary and parenteral route of delivery. The present review aims at the development of microsponge technology in oral drug delivery, preparation, formulation considerations, characterization, recent advancements, and future prospects of microsponge drug delivery.