Manufacturing and integration of MEMS devices by wafer bonding often lead to problems generated by thermal properties of materials. These include alignment shifts, substrate warping and thin film stress. By limiting the thermal processing temperatures, thermal expansion differences between materials can be minimized in order to achieve stress-free, aligned substrates without warpage. Achieving wafer level bonding at low temperature employs a little magic and requires new technology development. The cornerstone of low temperature bonding is plasma activation. The plasma is chosen to compliment existing interface conditions and can result in conductive or insulating interfaces. A wide range of materials including semiconductors, glasses, quartz and even plastics respond favorably to plasma activated bonding. The annealing temperatures required to create permanent bonds are typically ranging from room temperature to 400°C for process times ranging from 15-30 min and up to 2-3 h. This new technique enables integration of various materials combinations coming from different production lines.

Low temperature wafer bonding is a powerful technique for MEMS/MOEMS devices fabrication and packaging. Among the low temperature processes adhesive bonding focuses a high technological interest. Adhesive wafer bonding is a bonding approach using an intermediate layer for bonding (e.g. glass, polymers, resists, polyimides). The main advantages of this method are: surface planarization, encapsulation of structures on the wafer surface, particle compensation and decrease of annealing temperature after bonding. This paper presents results on adhesive bonding using spin-on glass and Benzocyclobutene (BCB) from Dow Chemicals. The advantages of using adhesive bonding for MEMS applications will be illustrated by presenting a technology of fabricating GaAs-on-Si substrates (up to 150 mm diameter) and results on BCB bonding of Si wafers (200 mm diameter).

Wafer bonding became during past decade an important technology for MEMS manufacturing and waferlevel 3D integration applications. The increased complexity of the MEMS devices brings new challenges to the processing techniques. In MEMS manufacturing wafer bonding can be used for integration of the electronic components (e.g. CMOS circuitries) with the mechanical (e.g. resonators) or optical components (e.g. waveguides, mirrors) in a single, wafer-level process step. However, wafer bonding with CMOS wafers brings additional challenges due to very strict requirements in terms of process temperature and contamination. These challenges were identified and wafer bonding process solutions will be presented illustrated with examples.

Metal bonding layers are used in various wafer bonding applications in MEMS and more recent in wafer-level 3D integration and optoelectronics. The bond process investigated in this paper is thermocompression. The most used metals for such applications are Cu, Au and Al, each of them with specific requirements for the wafer bonding process. While Au use doesn't face the problem of surface oxidation, both Cu and Al surfaces are covered by native oxides when exposed to ambient atmosphere: the oxidized surfaces impact on bonding process results, so their condition is crucial for successful process. The main process conditions for Cu-Cu and Al-Al bonding are reviewed and examples are presented.

Metal layers can be used as bonding layers at wafer-level in MEMS manufacturing processes for device assembly as well as just for electrical integration of different levels. One has to distinguish between two main types of processes: metal diffusion bonding and bonding with formation of an interface eutectic alloy layer or an intermetallic compound. The different process principles determine also the applications area for each. From electrical interconnections to wafer-level packaging (with emphasis on vacuum packaging) metal wafer bonding is a very important technology in MEMS manufacturing processes.