This article proposes a power-efficient highly linear capacitor-array-based digital-to-time converter (DTC) using a charge redistribution constant-slope approach. A fringecapacitor-based digital-to-analog converter (C-DAC) array is used to regulate the starting supply voltage of the constant discharging slope fed to a fixed-threshold comparator. The DTC operation mechanism is analyzed and design tradeoffs are investigated. The proposed DTC consumes merely 31 µW from a 1-V supply when clocked at 40 MHz, while achieving a fine resolution of 148 fs over a 9-bit range. The measured differential nonlinearity (DNL) and integral nonlinearity (INL) are 0.96/1.07 LSB.

Some rights reserved. For more information, please see the item record link above.

No abstract

No abstract

Nonlinearity of a digital-to-time converter (DTC) is pivotal to spur performance in DTC-based all-digital phaselocked-loops (ADPLL). In this paper, we characterize and analyze the mismatch of cascaded-delay-unit DTCs. Through an improved built-in-self-test (BIST) time-to-digital converter (TDC) assisted with phase-to-frequency detector (PFD), a measurement system of sub-half-ps accuracy is constructed to conduct the characterization. Fabricated in 28-nm CMOS, the DTC transfer functions are measured, and mismatches are compared against Monte-Carlo simulation results. The integral nonlinearity (INL) results are compared against each other and converted to the in-band fractional spur level when the DTC would be deployed in the ADPLL. The BIST-TDC system thus characterizes the on-chip delays without expensive equipment or complex setup. The effectiveness of adding a PFD into the loop is validated. The entire BIST system consumes 0.6 mW with a system self-calibration algorithm to tackle the analog blocks' nonlinearities.