We report a waveguide photodetector utilizing a hybrid waveguide structure consisting of AlGaInAs quantum wells bonded to a silicon waveguide. The light in the hybrid waveguide is absorbed by the AlGaInAs quantum wells under reverse bias. The photodetector has a fiber coupled responsivity of 0.31 A/W with an internal quantum efficiency of 90 % over the 1.5 mum wavelength range. This photodetector structure can be integrated with silicon evanescent lasers for power monitors or integrated with silicon evanescent amplifiers for preamplified receivers.

No abstract

Abstract-In this paper, we review the hybrid silicon photonic integration platform and its use for optical links. In this platform, a III/V layer is bonded to a fully processed silicon-on-insulator wafer. By changing the bandgap of the III/V quantum wells (QW), lowthreshold-current lasers, high-speed modulators, and photodetectors can be fabricated operating at wavelengths of 1.55 μm. With a QW intermixing technology, these components can be integrated with each other and a complete high-speed optical interconnect can be realized on-chip. The hybrid silicon bonding and process technology are fully compatible with CMOS-processed wafers because high-temperature steps and contamination are avoided. Full wafer bonding is possible, allowing for low-cost and large-volume device fabrication.

We report the first 1310 nm hybrid laser on a silicon substrate. This laser operates continuous wave (C.W.) up to 105 degrees C. The room temperature threshold current of this laser is 30 mA, and the maximum single sided fiber-coupled output power is 5.5 mW.

In this work we present both experimental and theoretical thermal analysis of an electrically pumped hybrid silicon evanescent laser. Measurements of an 850 µm long Fabry-Perot structure show an overall characteristic temperature of 51 o C, an above threshold characteristic temperature of 100 o C, and a thermal impedance of 41.8 o C/W. Finite element analysis of the laser structure predicts a thermal impedance of 43.5 o C/W, which is within 5% of the experimental results. Using the overall characteristic temperature, above threshold characteristic temperature, and the measured thermal impedance, the continuous wave output power vs. current from the laser is simulated and is in good agreement with experiment.